4 Revision History
Changes from C Revision (August 2016) to D Revision
- Changed Bus free time between start and stop specifications minimum from "4.7 μs" to "1.3 μs" in I2C/Smbus/PMBus Timing Requirements section Go
- Changed Hold time after (repeated) start, Repeated-start setup time, Stop setup time, and Clock high period specifications minimum from "0.26 μs" to "0.6 μs" in I2C/Smbus/PMBus Timing Requirements sectionGo
- Changed Data setup time specification minimum from "50 ns" to "100 ns" in I2C/Smbus/PMBus Timing Requirements sectionGo
- Changed Clock low period specification minimum from "0.5 μs" to "1.3 μs" in I2C/Smbus/PMBus Timing Requirements sectionGo
- Changed Clock/data fall time specification maximum from "120 ns" to "300 ns" in I2C/Smbus/PMBus Timing Requirements sectionGo
- Added Total capacitance of one bus line specification to I2C/Smbus/PMBus Timing Requirements sectionGo
- Clarified instructions in Programming section Go
- Updated Table 10Go
- Clarified Full Configuration Update While in Normal Mode sectionGo
- Added steps 6 through 9 in Design Requirements sectionGo
Changes from B Revision (December 2015) to C Revision
Changes from A Revision (August 2011) to B Revision
- Added Pin Configuration and Functions section, ESD Ratings table, Feature Description section, Device Functional Modes, Application and Implementation section, Power Supply Recommendations section, Layout section, Device and Documentation Support section, and Mechanical, Packaging, and Orderable Information sectionGo
- Changed minimum storage temperature from –40 to –55Go
- Changed the Functional Block DiagramGo
- Deleted the second paragraph under Monitoring sectionGo
- Updated Voltage Monitoring section.Go
- Updated pin numbers in GPIO Pin Configuration Options table.Go
- Updated first item in the GPI Special Functions section.Go
- Updated last sentence in Power-Supply Enables section.Go
- Updated JTAG INTERFACE section.Go
- Updated Programming section.Go