SLUU297B December   2007  – January 2022 TPS40195

 

  1.   Trademarks
  2. 1 Introduction
  3. 2 Description
    1. 2.1 Applications
    2. 2.2 Features
  4. 3 TPS40195EVM Electrical Performance Specifications
  5. 4 Schematic
    1. 4.1 Test Points
  6. 5 Test Setup
    1. 5.1 Equipment
      1. 5.1.1 Voltage Source
      2. 5.1.2 Meters
      3. 5.1.3 Loads
      4. 5.1.4 Oscilloscope
      5. 5.1.5 Signal Generator
      6. 5.1.6 Recommended Wire Gauge
      7. 5.1.7 Other
    2. 5.2 Equipment Setup
  7. 6 Test Procedure
    1. 6.1 Line and Load Regulation
    2. 6.2 Output Ripple Measurement (TP5, TP13)
    3. 6.3 Loop Analysis (TP7, TP8, TP10)
    4. 6.4 Disable (TP11) and Power Good (TP9)
    5. 6.5 Switch Node (TP4) and SYNC (TP12)
    6. 6.6 Equipment Shutdown
  8. 7 TPS40195EVM Typical Performance Data and Characteristic Curves
    1. 7.1 Line and Load Regulation
    2. 7.2 Efficiency
    3. 7.3 Output Voltage Ripple
    4. 7.4 Transient Response
    5. 7.5 Bode Plots
    6. 7.6 Test Point Waveforms
  9. 8 EVM Assembly Drawings and Layout
  10. 9 List of Materials
  11. 10Revision History

6.1 Line and Load Regulation

  1. Increase VIN from 0 V to 8 V.
  2. Step LOAD1 from 0 A to 20 A.
  3. Record, VIN, IIN, VOUT and IOUT for each LOAD1 step.
  4. Step VIN from 8 V to 20 V.
  5. Repeat 2 to 4 above for each VIN step.
  6. See Section 6.6 for equipment shut down.

See Section 7.1 and Section 7.2 for typical line and load regulation curves and efficiency results.