DLPU130 December   2023

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Additional Image
    2. 2.2 Power Requirements
    3. 2.3 Connector/Header Information
    4. 2.4 Boot Mode Pin Mapping
    5. 2.5 Debug Information
  8. 3Software
    1. 3.1 Software Installation
  9. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  10. 5Additional Information
    1. 5.1 Trademarks

1.3 Specification

Table 1-2 Recommended Operating Conditions
PARAMETER MIN NOM MAX UNIT
INPUT
Voltage 10.5 12 18 V
Supply current (PWM enabled)(1) 0.3 A
Supply current (PWM disabled) 0.2 A
Power (PWM enabled) 3.6 W
Power (PWM disabled) 2.4 W
LED Driver
Light engine efficiency(2) 29.5 %
LED power 1.31 W
Efficacy(3) 30.1 Lm/W
TEMPERATURE
Operating DMD temperature -40 25 105

°C
(1) Luminus SFT-03X-W, White LED, LED PWM Configuration = 450 of 1023, duty cycles: R0%, G100%, B0%. Any RGB channel can be used for monochromatic operation, but the green channel is used as the TI default.
(2) Efficiency defined as: (Luminous Flux x 100%)/Calculated Raw Lumens.
(3) Efficacy defined as: White ANSI Lumen/LED Power.
WARNING: When choosing the LED component (not included with this EVM), the user must consult the LED data sheet supplied by the LED manufacturer to identify the EN62471 Risk Group Rating and review any potential eye hazards associated with the LED chosen. Always consider and implement the use of effective light filtering and darkening protective eye wear and be fully aware of surrounding laboratory-type set-ups when viewing intense light sources that can be required to minimize or eliminate such risks to avoid accidents related to temporary blindness.
GUID-20231121-SS0I-L7Q9-QJG4-NJG17HN9HGZX-low.png

The block diagram is shown in Figure 2-1.

In this application, the Sitara MCU reads video data directly from a flash memory to display on the DMD. The Sitara MCU also coordinates the illumination timing to coordinate with the displayed video content.

GUID-20231120-SS0I-0RM3-DTHX-WFJ2V6SPLK38-low.gif Figure 1-1 Dynamic Ground Projection Electronics Block Diagram