SBAU358A November   2020  – June 2025 AFE10004

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Power Requirements
      1. 2.1.1 Configuring the EVM for a Positive Output Range
      2. 2.1.2 Configuring the EVM for a Negative Output Range
    2. 2.2 Header Information
    3. 2.3 Jumper Information
    4. 2.4 Interfaces
      1. 2.4.1 SPI Configuration
      2. 2.4.2 I2C Configuration
    5. 2.5 Test Points
  9. 3Software
    1. 3.1 Software Installation
    2. 3.2 Software Description
      1. 3.2.1 Launching the Software
      2. 3.2.2 Low Level Configuration Page
      3. 3.2.3 Block Diagram Page
      4. 3.2.4 Look Up Table Page
        1. 3.2.4.1 Loading and Saving LUT Files
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1. 5.1 Electrostatic Discharge Caution
    2. 5.2 Trademarks
  12. 6Related Documentation
  13. 7Revision History

2.5 Test Points

Table 2-7 defines the AFE10004EVM test points.

Table 2-7 Test Point Definitions
Designator Net Definition
TP1 D- AFE10004 D+
TP2 D+ AFE10004 D-
TP3 PA_ON AFE10004 PA_ON
TP4, TP5, TP6, TP7, TP8 GND Ground test points
TP9 VIO AFE10004 VIO
TP10 VDD AFE10004 VDD
TP11 VCC AFE10004 VCC
TP12 VSS AFE10004 VSS
TP13 3.3V Onboard 3.3V supply
TP14 1.8V Onboard 1.8V supply
TP15 USB_5V USB 5V supply
TP16 FTDI_TRIGGER Trigger from the FTDI