SLUUDA1 April   2025

 

  1.   1
  2.   Description
  3.   Applications
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specifications
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Power Requirements
    2. 2.2 Setup
    3. 2.3 Header Information
      1. 2.3.1 USB Interface
      2. 2.3.2 Communication Interfaces
      3. 2.3.3 GPIO Interface (Future Implementation)
    4. 2.4 Jumper Information
      1. 2.4.1 Pull-Up Interface
      2. 2.4.2 1MHz Pull-Up Interface
      3. 2.4.3 MCU Power Headers
    5. 2.5 Push Buttons
    6. 2.6 Interfaces
      1. 2.6.1 Overview
      2. 2.6.2 I2C Interface
      3. 2.6.3 SMBus Interface
      4. 2.6.4 SPI Interface (Future Implementation)
      5. 2.6.5 UART Interface (Future Implementation)
  8. 3Software
    1. 3.1 Software Description
    2. 3.2 Software Installation
    3. 3.3 GUI Installation
    4. 3.4 Software Development
    5. 3.5 Programming Options
  9. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  10. 5Additional Information
    1. 5.1 Trademarks
  11. 6Related Documentation

2.2 Setup

Figure 2-1 shows a typical setup for communication between a computer and a TI battery gauge using the EV2500. The following sections describe each of the jumper options available on the EV2500.

EV2500 Setup and Configuration

Figure 2-1 Setup and Configuration