JAJSH99C September   2000  – September 2022 INA118

PRODUCTION DATA  

  1. 1 特長
  2. 2 アプリケーション
  3. 3 概要
  4. 4 Revision History
  5. 5 Device Comparison Table
  6. 6 Pin Configuration and Functions
  7. 7 Specifications
    1. 7.1 絶対最大定格
    2. 7.2 ESD Ratings
    3. 7.3 Recommended Operating Conditions
    4. 7.4 Thermal Information
    5. 7.5 Electrical Characteristics
    6. 7.6 Typical Characteristics
  8. 8 Detailed Description
    1. 8.1 Overview
    2. 8.2 Functional Block Diagram
    3. 8.3 Feature Description
    4. 8.4 Device Functional Modes
      1. 8.4.1 Noise Performance
      2. 8.4.2 Input Common-Mode Range
      3. 8.4.3 Input Protection
  9. 9 アプリケーションと実装
    1. 9.1 アプリケーション情報
    2. 9.2 Typical Application
      1. 9.2.1 Design Requirements
      2. 9.2.2 Detailed Design Procedure
        1. 9.2.2.1 Setting the Gain
        2. 9.2.2.2 Dynamic Performance
        3. 9.2.2.3 Offset Trimming
        4. 9.2.2.4 Input Bias Current Return Path
      3. 9.2.3 アプリケーション曲線
    3. 9.3 Power Supply Recommendations
      1. 9.3.1 Low-Voltage Operation
      2. 9.3.2 Single-Supply Operation
    4. 9.4 Layout
      1. 9.4.1 Layout Guidelines
      2. 9.4.2 Layout Example
  10. 10Device and Documentation Support
    1. 10.1 Device Support
      1. 10.1.1 Development Support
    2. 10.2 Receiving Notification of Documentation Updates
    3. 10.3 サポート・リソース
    4. 10.4 Trademarks
    5. 10.5 Electrostatic Discharge Caution
    6. 10.6 Glossary
  11. 11Mechanical, Packaging, and Orderable Information

パッケージ・オプション

メカニカル・データ（パッケージ｜ピン）
サーマルパッド・メカニカル・データ
発注情報

6 Pin Configuration and Functions

GUID-D57068D1-9563-4207-891C-46E75B24C9A3-low.gif Figure 6-1 P (8-Pin PDIP) and D (8-Pin SOIC) Packages, Top View
Table 6-1 Pin Functions
PIN TYPE DESCRIPTION
NO. NAME
1 RG — Gain setting pin. For gains greater than 1, place a gain resistor between pin 1 and pin 8.
2 V–IN Input Negative input
3 V+IN Input Positive input
4 V– Power Negative supply
5 Ref Input Reference input. This pin must be driven by low impedance or connected to ground.
6 VO Output Output
7 V+ Power Positive supply
8 RG — Gain setting pin. For gains greater than 1, place a gain resistor between pin 1 and pin 8.