SLAU151B may   2023  – june 2023 DAC8801 , DAC8811

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Power Requirements
    2. 2.2 Jumper Information
    3. 2.3 Setup
    4. 2.4 Header Information
    5. 2.5 Test Points
  8. 3Software
    1. 3.1 GUI Installation
    2. 3.2 Software Description
  9. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  10. 5Compliance Information
    1. 5.1 Compliance and Certifications
  11. 6Related Documentation
    1. 6.1 Supplemental Content
  12. 7Revision History

2.5 Test Points

The DAC8811EVM has a variety of test points available for measuring and debugging purposes. Table 3-4 explains the purpose of each test point.

Table 2-4 DAC8811EVM Test Points
Test Point Net Description
TP1 VDAC Output of DAC8811, ranges from 0-V to negative VREF
TP2 VREF DAC8811 reference voltage
TP3, not installed +IN_A Non-inverting input of the first op amp in OPA2828
TP4, not installed +IN_B Non-inverting input of the second op amp in OPA2828
TP5, not installed -IN_A Inverting input of the first op amp in OPA2828
TP6 VOUT ±10-V output of OPA2828 circuit
TP7 REF 2p5V Onboard 2.5-V reference provided by REF5025
TP8, not installed REF_TEMP TEMP pin of REF5025
TP9 USB 5 V Onboard 5-V provided by USB connection
TP10 LDO 3p3V Onboard 3.3-V supply provided by TPS73433-Q1
TP11, TP12, TP13, TP14, TP15 GND Ground connection