SLAU298A November 2009 – May 2021
Figure 6-5 shows the Register Map page. This page can only be accessed by selecting Software device mode. Editing the CONFIG_REG configures the different ranges and voltage references available on the ADS8555. See the ADS8555 data sheet for register field details. The left hand side of this GUI contains important configurations such as interface selection, device mode, range selection, and sampling rate. These controls are always available on the left hand side of the GUI regardless of which page is selected. Also, if Hardware mode is used, the hardware input select pins on the device are set according the controls on the left hand side. For example, when in hardware mode if the Parallel Interface is selected, than the PAR/SER pin on the device is driven low by the PHI to select parallel interface mode.