SLAU813A September   2019  – October 2020 TPA6304-Q1

 

  1.   Trademarks
  2. 1Required Equipment and Accessories:
  3. 2Hardware Overview
    1. 2.1 TPA6304Q1 Evaluation Module Description
    2. 2.2 TPA6304-Q1 Evaluation Module Functions
  4. 3Software Overview
    1. 3.1 PurePath™ Console 3 (PPC3) Access and Description
    2. 3.2 PurePath™ Console 3 – TPA6304Q1EVM Home Window
    3. 3.3 PurePath™ Console 3 – TPA6304Q1EVM Register Map Window
    4. 3.4 PurePath™ Console 3 – TPA6304Q1EVM Monitor & Control Window
  5. 4TPA6304-Q1 Start Up
    1. 4.1 TPA6304Q1EVM Setup
    2. 4.2 TPA6304-Q1 Settings on Device Monitor & Control Window
      1. 4.2.1 Device State Control Section
      2. 4.2.2 Channel Control Section
      3. 4.2.3 Miscellaneous Control Section
      4. 4.2.4 Fault / Warning Signal Configuration Section
      5. 4.2.5 Faults / Warnings Section
      6. 4.2.6 AC Load Diagnostics Section
      7. 4.2.7 DC Load Diagnostics Section
      8. 4.2.8 Spread Spectrum Control Section
    3. 4.3 TPA6304-Q1 Settings on Register Map Window
    4. 4.4 I2C Monitor Window
  6. 5Board Layout, Schematic and Bill of Materials
    1. 5.1 Board Layout
    2. 5.2 Schematic
    3. 5.3 Bill of Materials
  7.   Revision History

4.1 TPA6304Q1EVM Setup

GUID-20200915-CA0I-NDMG-XRDR-VPCBKC4TLQG4-low.pngFigure 4-1 TPA6304Q1EVM Connections

Hardware and software connections:

  • Desktop or laptop PC running Windows 7 or 10, open PPC3 GUI
  • Connect 14.4-VDC PSU to the TPA6304Q1EVM
  • Connect speakers or resistive loads to the TPA6304Q1EVM
  • Connect USB micro cable from the PC to the EVM
  • Set the STANDBY switch to down position and the XMOS DISABLE switch to the up position
  • Turn on the PSU
  • Connect the audio source – this can be a 3-mm stereo connector connected from the PC to the EVM as shown in Figure 4-1
  • At this point, 3.3V LED, and USB-LOCK LED are on
  • On the PPC3 window, launch the TPA6304Q1EVM application
  • Click Connect at the bottom left corner of the window
  • Click Device Monitor & Control
  • Click on Play at the top left corner of the window
  • On the PC make sure the volume level is set as desired
  • On the EVM, first switch up the STANDBY switch
  • The audio can now be streamed to the speakers