SLLU344 February   2022 TIOL112 , TIOL1123 , TIOL1125 , TIOS102 , TIOS1023 , TIOS1025

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 Features
    2. 1.2 Description
  3. 2EVM Setup and Features Explained
    1. 2.1 Evaluation Equipment
    2. 2.2 Power Overview
    3. 2.3 Current Limit Overview
    4. 2.4 Fault Reporting (NFAULT)
    5. 2.5 Transient Protection and Custom Loads
    6. 2.6 IO-Link Communication (TIOL112x)
    7. 2.7 Digital Sensor Output Driver Control (TIOS102x and TIOS112x)
    8. 2.8 EVM Jumper Settings
  4. 3Schematic and Bill of Materials
    1. 3.1 Schematic
    2. 3.2 Bill of Materials
  5. 4Revision History

2.6 IO-Link Communication (TIOL112x)

The communication and control signals of the TIOL112x (TX, RX, EN, WAKE, and NFAULT) can be connected to a microcontroller that is implementing an IO-Link protocol stack through pins 3 (RX), 4 (TX), 5 (EN), 8 (WAKE) of header J10 as well as pin 19 (NFAULT) of header J11. Test points for each of these signals are also provided next to the header pins, allowing the signals to be monitored or connected to additional test equipment, such as oscilloscope probes and logic analyzers.