THS6184
- Trimmed Low-Power Consumption
- 4.2-mA/amp Full Bias Mode; 4.8 mA Max
- 3.2-mA/amp Mid Bias Mode; 3.7 mA Max
- 2.15-mA/amp Low Bias Mode; 2.5 mA Max
- Shutdown Mode and IADJ Pin for Variable Bias
- Low Noise
- 3-nV/√Hz Voltage Noise
- 5.9-pA/√Hz Inverting Current Noise
- 1.2-pA/√Hz Noninverting Current Noise
- Low MTPR Distortion
- -74 dB with ADSL and ADSL2
- -71 dB with ADSL2+ and -70 dB with ADSL2++
- -83 dBc THD (1 MHz, 100-Ω Differential)
- High Output Current: >415 mA (25-Ω Load)
- Wide Output Swing: 44 VPP (±12-V, 200-Ω Differential)
- Wide Bandwidth: 30 MHz (Gain = 5)
- Wide Power Supply Range: ±4 V to ±16 V
- APPLICATIONS
- Ideal For Power Sensitive, High Density ADSL, ADSL2, ADSL2+, and ADSL2++ Systems
PowerPAD is a trademark of Texas Instruments.
All other trademarks are the property of their respective owners
The THS6184 is a dual-port, low-power current feedback differential line driver amplifier system ideal for xDSL systems. Its extremely low-power dissipation is ideal for ADSL, ADSL2, ADSL2+, and ADSL2++ systems that must achieve high densities in ADSL central office applications by combining two ports, or four amplifiers, into one package.
The unique architecture of the THS6184 allows the trimmed quiescent current to be much lower than existing line drivers while still achieving high linearity. Distortion at these low-power levels is good with -83-dBc THD at 1 MHz with the low bias mode of 4.2 mA/port. Fixed and variable multiple-bias settings of the amplifiers allows for enhanced power savings for line lengths where the full performance of the amplifier is not required.
The wide output swing of 44-VPP differentially with ±12-V power supplies coupled with over 415-mA current drive allow for wide dynamic range, keeping distortion minimized. With a low 3-nV/√ Hz voltage noise coupled with a low 5.9-pA/√Hz inverting current noise, the THS6184 increases the sensitivity of the receive signals allowing for better margins and reach.
기술 문서
유형 | 직함 | 날짜 | ||
---|---|---|---|---|
* | Data sheet | Dual Port Low Power Differential xDSL Line Driver Amplifiers datasheet (Rev. D) | 2009/01/08 | |
E-book | The Signal e-book: A compendium of blog posts on op amp design topics | 2017/03/28 | ||
Application note | Noise Analysis for High Speed Op Amps (Rev. A) | 2005/01/17 |
설계 및 개발
추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.
PSPICE-FOR-TI — TI 설계 및 시뮬레이션 툴용 PSpice®
TI 설계 및 시뮬레이션 환경용 PSpice는 기본 제공 라이브러리를 이용해 복잡한 혼합 신호 설계를 시뮬레이션할 수 있습니다. 레이아웃 및 제작에 (...)
TINA-TI — SPICE 기반 아날로그 시뮬레이션 프로그램
패키지 | 핀 | 다운로드 |
---|---|---|
HTSSOP (PWP) | 20 | 옵션 보기 |
VQFN (RHF) | 24 | 옵션 보기 |
주문 및 품질
- RoHS
- REACH
- 디바이스 마킹
- 납 마감/볼 재질
- MSL 등급/피크 리플로우
- MTBF/FIT 예측
- 물질 성분
- 인증 요약
- 지속적인 신뢰성 모니터링
- 팹 위치
- 조립 위치