SCLK051 December   2023 TPS7H2201-SP

PRODUCTION DATA  

  1.   1
  2.   Trademarks
  3. 1Device Information
    1. 1.1 Product Description
    2. 1.2 Device Details
  4. 2Total Dose Test Setup
    1. 2.1 Test Overview
    2. 2.2 Test Description and Facilities
    3. 2.3 Test Setup Details
      1. 2.3.1 Unbiased
      2. 2.3.2 Biased
    4. 2.4 Test Configuration and Condition
  5. 3TID Characterization Test Results
    1. 3.1 TID Characterization Summary Results
    2. 3.2 TPS7H2201-QMLP Data Sheet Electrical Parameters
  6. 4Applicable and Reference Documents
    1. 4.1 Applicable Documents
    2. 4.2 Reference Documents
  7.   A Appendix: HDR TID Report Data

3.2 TPS7H2201-QMLP Data Sheet Electrical Parameters

ParameterTest ConditionsMINTYPMAXUnitSpecification IDTest Number
POWER SUPPLIES AND CURRENTS
VINHUVLO1.32VVIN_UVLO_Rising5.0
VINLUVLO1.23VVIN_UVLO_Falling5.1
HYSTVIN-UVLO92mVVIN_Hysteresis5.2
IQIOUT = 0 mA, VIN = EN = 5 V, CS resistor of 20 kΩ to GND, IOUT = 0 mA, VIN = EN = 5 V, CS resistor of 20 kΩ to GND2.46.5mAIQ_VIN_5V3.6
IFEN = VOUT = GND, measured VOUT current, 1.5 V ≤ VIN ≤ 7 V250µA
IFEN = VOUT = GND, measured VOUT current, VIN =1.5 V3.27µAFORWARD_LEAKAGE4.1, 4.3, 4.5, 4.7, 4.9
IFEN = VOUT = GND, measured VOUT current, VIN = 1.8 V3.35µAFORWARD_LEAKAGE_VIN_1p5V4.1
IFEN = VOUT = GND, measured VOUT current, VIN= 3.3 V3.62µAFORWARD_LEAKAGE_VIN_3p3V4.5
IFEN = VOUT = GND, measured VOUT current, VIN = 5 V4.11µA
IFEN = VOUT = GND, measured VOUT current, VIN = 7 V6.82µAFORWARD_LEAKAGE_VIN_5V4.5
ISD VINEN = GND, IOUT = 0 mA, measured VIN current, VIN = 5 V0.43mAISD_VIN_5V4.6
ISD VINEN = GND, IOUT = 0 mA, measured VIN current, VIN = 3.3 V0.33mAISD_VIN_3p3V4.4
ISD VINEN = GND, IOUT = 0 mA, measured VIN current, VIN = 1.8 V0.23mAISD_VIN_1p8V4.2
ISD VINEN = GND, IOUT = 0 mA, measured VIN current, VIN = 1.8, 3.3, and 5 V3.1mAISD_VIN_1p8V4.2
IRCPEN = 0 V, VIN = 0 to 7 V, VOUT = 0 to 7 V for VOUT > VIN, EN = 0 V, VIN = 0 to 7 V, VOUT = 0 to 7 V for VOUT > VIN0.4520mAIRCP_EN_0V3.1, 3.3, 3.5, 3.9
IRCPEN = 7 V, VIN = 0 V, VOUT = 0 to 7 V, EN = 7 V, VIN = 0 V, VOUT = 0 to 7 V0.4520mAIRCP_EN_7V3.10, 22.16, 3.11, 22.18
SOFT START
ISS1 V on SS pin, 1 V on SS pin6583µASS_I_Charge6.3, 6.7, 6.11, 6.15, 6.19
SRSSSS pin floating, COUT = 10 µF, SS pin floating, COUT = 10 µF295mV/µsSS_Slew_Rate
ENABLE AND UNDERVOLTAGE LOCKOUT (EN/UVLO) INPUT
VIHEN0.560.610.65VEN_VTH_RISING6.0, 6.4, 6.8, 6.12, 6.16
VILEN0.470.510.55VEN_VTH_FALLING6.1, 6.5, 6.9, 6.13, 6.17
HYSTEN93124mVEN_HYST6.2, 6.6, 6.10, 6.14, 6.18
tLOWRTIMER = GND, IL = 1 A, IVOUT = 2 A20µsEN_LOW_TIME
VINEN75%VIN_EN_PERCENTAGE
IENEN = VIN = 5 V, EN = VIN = 5 V12nAIEN_VIN_5V
OVERVOLTAGE PROTECTION (OVP)
VOVPR0.520.570.63VOVP_VTH_Rising7.0, 7.3, 7.6, 7.9, 7.12
VOVPF0.50.550.59VOVP_VTH_Falling7.1, 7.4, 7.7, 7.10, 7.13
HYSTOVP1.6 V < VIN < 7 V, 1.6 V < VIN < 7 V2055mVOVP_HYST7.2, 7.5, 7.8, 7.11, 7.14
IOVP15nAOVP_ILEAK7.15, 7.16, 7.17, 7.18, 7.19
CURRENT LIMIT AND CURRENT SENSE
tCSENCSS = 120 nF, CSS = 120 nF5msCS_EN_TIME13.0, 13.1
Minimum VOUT current for valid CS output750mAMIN_VOUT_CURR_CS
VOUT current change to CS change delay time0.5-A rising step, 100 mA/µs, 1.5 V ≤ VIN ≤ 7 V, 0.5-A rising step, 100 mA/µs, 1.5 V ≤ VIN ≤ 7 V1674µsIOUT_CS_DELAY_RISING40.1, 40.3, 40.5, 40.7, 40.9
VOUT current change to CS change delay time0.5-A falling step, 100 mA/µs, 1.5 V ≤ VIN ≤ 7 V, 0.5-A falling step, 100 mA/µs, 1.5 V ≤ VIN ≤ 7 V1673µsIOUT_CS_DELAY_FALLING40.0, 40.2, 40.4, 40.6, 40.8
CS pin accuracy0.75 A ≤ IVOUT ≤ 7.5 A, 0.75 A ≤ IVOUT ≤ 7.5 A–10%10%CS_ACCURACY9.9, 9.19
CS pin voltage0.75 A ≤ IVOUT ≤ 7.5 A, no OCP, 0.75 A ≤ IVOUT ≤ 7.5 A, no OCPVIN – 0.4VCS_VOLTAGE
Current limit setting, IILIVOUT ≤ 1 A, IVOUT ≤ 1 AIVOUT + 0.5ACURR_LIMIT_SET_LESS_1A
Current limit setting, IIL1 A < IVOUT ≤ 3 A, 1 A < IVOUT ≤ 3 AIVOUT + 1ACURR_LIMIT_SET_GREATER_1A
Current limit setting, IILIVOUT > 3 A, IVOUT > 3 AIVOUT + 1.5ACURR_LIMIT_SET_GREATER_3A
Programmable current limit accuracy1.5 V ≤ VIN ≤ 7 V, 1.5 V ≤ VIN ≤ 7 V–20%20%Current_Limit_Accuracy30.3, 30.7, 30.11, 30.15, 30.19, 30.23, 30.27, 30.31, 30.35, 30.39, 30.43, 30.47, 30.51, 30.55, 30.59
Fast trip off current limitVIN = 5 V, 10-mΩ short in 10 µs, VIN = 5 V, 10-mΩ short in 10 µs22AFTO_Current_Limit
Fast trip off off-timeVIN = 5 V, CSS = 2.7 nF, VIN = 5 V, CSS = 2.7 nF61158µsFTO_OFF_TIME
Internal current limit timer (fast trip off current limit)VIN = 5 V, IVOUT = 3 A, IL = 6 A, ILTIMER = VIN, 10-mΩ short in 10 µs15µsCurrent_Limit_Timer
TIMERS
IILTIMER0.711.38µAILTIMER_CHARGE_CURR12.0, 12.2
PDILTIMER40 mV on ILTIMER pin, 40 mV on ILTIMER pin38153ΩILTIMER_PDR35.0, 35.2, 35.4, 35.6, 35.8
IRTIMER0.711.38µARTIMER_CHARGE_CURR12.1, 12.3
PDRTIMER40 mV on RTIMER pin, 40 mV on RTIMER pin38153ΩRTIMER_PDR35.1, 35.3, 35.5, 35.7, 35.9
THERMAL SHUTDOWN
Thermal shutdownVIN = 5 V, VIN = 5 V175°CThermal_SHDN
Thermal shutdown hysteresisVIN = 5 V, VIN = 5 V20°CThermal_SHDN_Hyst
RESISTANCE CHARACTERISTICS
RONVIN = 7 V, IIL = 7.5 A, 25°C19.921mΩRON_VIN_7V_25_Plastic8.4
RONVIN = 5 V, IIL = 7.5 A, 25°C21.423mΩRON_VIN_5V_25_Plastic8.3
RONVIN = 3.3 V, IIL = 7.5 A, 25°C24.526mΩRON_VIN_3P3V_25_Plastic8.2
RONVIN = 1.8 V, IIL = 7.5 A, 25°C34.937mΩRON_VIN_1P8V_25_Plastic8.1
RONVIN = 1.5 V, IIL = 7.5 A, 25°C42.746mΩRON_VIN_1P5V_25_Plastic8.0