SLAU969 December   2025

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Hardware Overview
    2. 2.2 Power Requirements
    3. 2.3 XDS110 Debug Probe
    4. 2.4 Measure Current Draw of the MSPM33C321A
    5. 2.5 Clocking
    6. 2.6 BoosterPack Plug-in Module Pinout
    7. 2.7 Mikrobus Module Pinout
    8. 2.8 External Storage
    9. 2.9 OLED Display Module
  9. 3Software
    1. 3.1 Software Development Options
    2. 3.2 Out-of-Box
    3. 3.3 CCS Cloud
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  11. 5Compliance Information
    1. 5.1 Compliance and Certifications
  12. 6Additional Information
    1. 6.1 Trademarks
  13. 7Related Documentation
    1. 7.1 Supplemental Content
  14. 8Revision History

2.2 Power Requirements

The LP-MSPM33C321A only needs the USB plugged in and debugger jumper block populated to power the device. With the onboard LDO, the 5V USB supply is converted to 3.3V with a supply of 500mA. The LaunchPad can also be powered by the 3.3V or 5V headers via an external supply. Do not exceed 3.3V on the 3.3V rail or 5V on the 5V rail. For operation of the Low-Frequency Subsystem Module (LFSS), the BAT jumper needs to be populated or powered with 1.65 - 3.3V.

LP-MSPM33C321A LP-MSPM33C321A Power Connections Figure 2-2 LP-MSPM33C321A Power Connections