SLUUCV0B August   2023  – April 2024 TPSM8287A06 , TPSM8287A10 , TPSM8287A12 , TPSM8287A15

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  6. 2Hardware
    1. 2.1 Safety Instructions
    2. 2.2 Header Information
    3. 2.3 Jumper Information
    4. 2.4 Interfaces
    5. 2.5 Test Points
  7. 3Software
  8. 4Implementation Results
    1. 4.1 Evaluation Setup
      1. 4.1.1 Ripple Measurement Setup
      2. 4.1.2 Operation With Output Voltages Above 2V
      3. 4.1.3 Loop Response Measurement
      4. 4.1.4 Precise Turn-on Voltage
    2. 4.2 Performance Data and Results
  9. 5Hardware Design Files
    1. 5.1 Schematics
    2. 5.2 PCB Layouts
    3. 5.3 Bill of Materials (BOM)
  10. 6Additional Information
    1. 6.1 Trademarks
  11. 7Revision History

Header Information

J1 VIN/GND

Input and return connections from the input supply to the EVM.

This connector accepts up to 12 AWG wire.

MH1/2 – VIN/GND

Alternate input and return connections from the input supply to the EVM.

These holes are sized for M4 or #8 bolts.

J2 VOUT/GND

Input and return connections from the EVM to the load.

This connector accepts up to 12 AWG wire.

MH3/4 – VOUT/GND

Alternate input and return connections from the EVM to the load.

These holes are sized for M4 or #8 bolts.

J3 – PG/GNDThe PG output appears on pin 2 of this header with ground on pin 1.
J4 – SYNC_OUT/GNDThe SYNC_OUT signal appears on pin 1 of this header with ground on pin 2.
J6 – VOUT SMAMeasure the output voltage waveform at this SMA connector.