SLVSA31A November   2009  – December 2014 TPS61029-Q1

PRODUCTION DATA.  

  1. Features
  2. Applications
  3. Description
  4. Simplified Schematic
  5. Revision History
  6. Device Comparison Table
  7. Pin Configuration and Functions
  8. Specifications
    1. 8.1 Absolute Maximum Ratings
    2. 8.2 ESD Ratings
    3. 8.3 Recommended Operating Conditions
    4. 8.4 Thermal Information
    5. 8.5 Electrical Characteristics
  9. Typical Characteristics
  10. 10Parameter Measurement Information
  11. 11Detailed Description
    1. 11.1 Functional Block Diagram (TPS61029)
    2. 11.2 Feature Description
      1. 11.2.1 Controller Circuit
        1. 11.2.1.1 Synchronous Rectifier
        2. 11.2.1.2 Down Regulation
        3. 11.2.1.3 Device Enable
        4. 11.2.1.4 Softstart and Short Circuit Protection
        5. 11.2.1.5 Low Battery Detector Circuit—LBI/LBO
        6. 11.2.1.6 Low-EMI Switch
    3. 11.3 Device Functional Modes
      1. 11.3.1 Undervoltage Lockout
      2. 11.3.2 Power Save Mode
    4. 11.4 Programming
      1. 11.4.1 Programming the Output Voltage
      2. 11.4.2 Programming the LBI/LBO Threshold Voltage
  12. 12Application and Implementation
    1. 12.1 Application Information
      1. 12.1.1 Application Examples
    2. 12.2 Typical Application
      1. 12.2.1 Design Requirements
        1. 12.2.1.1 Inductor Selection
        2. 12.2.1.2 Input Capacitor
        3. 12.2.1.3 Output Capacitor
      2. 12.2.2 Detailed Design Procedure
        1. 12.2.2.1 Small Signal Stability
        2. 12.2.2.2 Thermal Information
      3. 12.2.3 Application Curves
  13. 13Power Supply Recommendations
  14. 14Layout
    1. 14.1 Layout Guidelines
    2. 14.2 Layout Example
  15. 15Device and Documentation Support
    1. 15.1 Documentation Support
      1. 15.1.1 Third-Party Products Disclaimer
    2. 15.2 Related Links
    3. 15.3 Trademarks
    4. 15.4 Electrostatic Discharge Caution
    5. 15.5 Glossary
  16. 16Mechanical, Packaging, and Orderable Information

13 Power Supply Recommendations

This input supply should be well regulated with the rating of TPS6102x. If the input supply is located more than a few inches from the device, additional bulk capacitance may be required in addition to the ceramic bypass capacitors. An electrolytic or tantalum capacitor with a value of 47 μF is a typical choice.