SLVU281B May   2009  – August 2021 TPS54620

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 Background
    2. 1.2 Performance Specification Summary
    3. 1.3 Modifications
      1. 1.3.1 Output Voltage Set Point
      2. 1.3.2 Slow Start Time
      3. 1.3.3 Track In
      4. 1.3.4 Adjustable UVLO
      5. 1.3.5 Input Voltage Rails
  3. 2Test Setup and Results
    1. 2.1  Input / Output Connections
    2. 2.2  Efficiency
    3. 2.3  Output Voltage Load Regulation
    4. 2.4  Output Voltage Line Regulation
    5. 2.5  Load Transients
    6. 2.6  Loop Characteristics
    7. 2.7  Output Voltage Ripple
    8. 2.8  Input Voltage Ripple
    9. 2.9  Powering Up
    10. 2.10 Thermal Characteristics
  4. 3Board Layout
    1. 3.1 Layout
    2. 3.2 Estimated Circuit Area
  5. 4Schematic and Bill of Materials
    1. 4.1 Schematic
    2. 4.2 Bill of Materials
  6. 5Revision History

Input / Output Connections

The TPS54620EVM-374 is provided with input/output connectors and test points as shown in Table 2-1. A power supply capable of supplying 4 A must be connected to J1 through a pair of 20 AWG wires. The jumper across J3 must be in place. See Section 1.3.5 for split input voltage rail operation. The load must be connected to J7 through a pair of 20 AWG wires. The maximum load current capability must be 6 A. Wire lengths must be minimized to reduce losses in the wires. Test-point TP1 provides a place to monitor the VIN input voltages with TP2 providing a convenient ground reference. TP8 is used to monitor the output voltage with TP9 as the ground reference.

Table 2-1 EVM Connectors and Test Points
Reference DesignatorFunction
J1PVIN input voltage connector. (see Table 1-1 for VIN range).
J2VIN input voltage connector. Not normally used.
J3PVIN to VIN jumper. Normally closed to tie VIN to PVIN for common rail voltage operation.
J242-pin header for enable. Connect EN to ground to disable, open to enable.
J52-pin header for tracking voltage input and ground.
J62-pin header for tracking output and ground.
J7VOUT, 3.3 V at 6 A maximum.
TP1PVIN test point at PVIN connector.
TP2GND test point at PVIN connector.
TP3VIN test point at VIN connector.
TP4GND test point at VIN connector.
TP5PH test point.
TP6Slow start / track in test point.
TP7Test point between voltage divider network and output. Used for loop response measurements.
TP8Output voltage test point at VOUT connector
TP9GND test point at VOUT connector
TP10PWRGD test point.