SLVU358A February   2010  – January 2022 TPS51513

 

  1.   Trademarks
  2. 1 Description
    1. 1.1 Typical Application
    2. 1.2 Features
  3. 2 Electrical Performance Specifications
  4. 3 Schematic
  5. 4 Test Setup
    1. 4.1 Test Equipment
    2. 4.2 Recommended Test Setup
  6. 5 Configuration
    1. 5.1 Current Limit Trip Selection (J8: Trip Select)
    2. 5.2 Frequency Selection (J7: TON Select)
    3. 5.3 Overshoot Reduction Selection (J9: OSRTM Select)
    4. 5.4 VID Bits Selection (S1)
    5. 5.5 Sleep Mode Selection (SLP)
    6. 5.6 1.2-V Output Voltage Option (J10: VOUT selection)
  7. 6 Test Procedure
    1. 6.1 Line/Load Regulation and Efficiency Measurement Procedure
    2. 6.2 List of Test Points
    3. 6.3 Equipment Shutdown
  8. 7 Performance Data and Typical Characteristic Curves
    1. 7.1  Efficiency
    2. 7.2  Load Regulation
    3. 7.3  Line Regulation
    4. 7.4  Current Monitor Voltage
    5. 7.5  Output Ripple
    6. 7.6  Switching Node
    7. 7.7  Output Transient
    8. 7.8  Turn-On Waveform
    9. 7.9  Turn-Off Waveform
    10. 7.10 Bode Plot
  9. 8 EVM Assembly Drawing and PCB Layout
  10. 9 Bill of Materials
  11. 10Revision History

1.2 Features

The TPS51513EVM-549 features:

  • Output voltage variable from 0.70 V to 1.05 V through a 3-bit VID DAC or fixed 1.2-V option
  • 20-ADC steady-state current
  • Selectable 250, 300, 350, or 500-kHz switching frequency
  • Selectable current limit
  • Selectable output overshoot reduction (OSR™)
  • J6 for enable function
  • Convenient test points for probing critical waveforms
  • Six-layer PCB with 2-oz copper on the outside layer