SBOU261 October   2021 ISOUSB211

 

  1.   Trademarks
  2. 1Introduction
  3. 2Overview
  4. 3Pin Configuration of the ISOUSB211 High-, Full-, and Low-Speed Isolated USB Repeater
  5. 4EVM Setup and Operation
  6. 5EVM Schematics
  7. 6PCB Layout and 3D Diagram
  8. 7Bill of Materials

6 PCB Layout and 3D Diagram

Figure 6-1 through Figure 6-3 show the printed-circuit board (PCB) layout top, middle and bottom layers, respectively. Figure 6-4 shows a 3D diagram of the PCB indicating the look of a finished board.

Figure 6-1 ISOUSB211DPEVM PCB Layout - Top Layer
Figure 6-2 ISOUSB211DPEVM PCB Layout - Middle Layer
Figure 6-3 ISOUSB211DPEVM PCB Layout - Bottom Layer
Figure 6-4 ISOUSB211DPEVM PCB 3D View