SLAU823 October   2019 TMUXHS4212

 

  1.   TMUXHS4212 Evaluation Module User's Guide
    1.     Trademarks
    2. 1 Introduction
    3. 2 Setup and Configuration
      1. 2.1 Signal Connection
      2. 2.2 AC Coupling Capacitors
      3. 2.3 Jumper Configuration
      4. 2.4 Power
      5. 2.5 Calibration
      6. 2.6 REACH Compliance
    4. 3 Schematics
    5. 4 Bill of Materials
      1. 4.1 TMUXHS4212EVM BOM

2.3 Jumper Configuration

The TMUXHS4212 is controlled by an active-low enable signal and a port select signal. Jumper J8 is used to enable or disable the switch. Jumper J7 controls the port selection: Port A to Port B, or Port A to Port C. Both jumpers and their operational positions are labeled with silkscreens on the EVM for ease of use.