SLUUAV7C December   2013  – November 2022

 

  1.   Abstract
  2.   Trademarks
  3. 1Features
    1. 1.1 Kit Contents
    2. 1.2 Ordering Information
    3. 1.3 Documentation
    4. 1.4 bq40z50 and bq296000 Circuit Module Performance Specification Summary
  4. 2bq40z50EVM Quick Start Guide
    1. 2.1 Items Needed for EVM Setup and Evaluation
    2. 2.2 Software Installation
    3. 2.3 EVM Connections
    4. 2.4 Update Firmware
  5. 3Battery Management Studio
    1. 3.1 Registers Screen
    2. 3.2 Setting Programmable bq40z50 Options
    3. 3.3 Calibration Screen
      1. 3.3.1 Voltage Calibration
      2. 3.3.2 Temperature Calibration
      3. 3.3.3 Current Calibration
    4. 3.4 Chemistry Screen
    5. 3.5 Firmware Screen
      1. 3.5.1 Programming the Flash Memory
      2. 3.5.2 Exporting the Flash Memory
    6. 3.6 Advanced Comm SMB Screen
  6. 4bq40z50EVM Circuit Module Schematic
    1. 4.1 Pre-Charge
    2. 4.2 LED Control
    3. 4.3 Emergency Shutdown
    4. 4.4 Testing Fuse-Blowing Circuit
    5. 4.5 PTC Thermistor
  7. 5Circuit Module Physical Layouts
    1. 5.1 Board Layout
    2. 5.2 Schematic
  8. 6Bill of Materials
  9. 7Related Documentation from Texas Instruments
  10. 8Revision History

3.5.2 Exporting the Flash Memory

The lower section of the Firmware screen is used to export all of the flash memory from the device (see Figure 3-5).

  • Press the Browse button and enter an .srec filename.
  • Press the Read Srec to save the flash memory contents to the file. Wait for the download to complete.