SLVUC18 November   2020 TPS25865-Q1

 

  1.   Trademarks
  2. 1Introduction
    1. 1.1 Features
    2. 1.2 Applications
  3. 2Schematic
  4. 3General Configuration and Description
    1. 3.1 Physical Access
    2. 3.2 Adjusting the Switching Frequency
    3. 3.3 Current Limit Value
    4. 3.4 Cable Compensation Value
    5. 3.5 Thermal Management
    6. 3.6 Test Setup
  5. 4Board Layout
  6. 5Bill of Materials

3.6 Test Setup

Figure 3-1 shows a typical test setup for charging the USB Type-A device. Connect VIN+ to the power supply. Connect the USB Type-A device to the J1 and J3 connector.

Figure 3-1 EVM Setup for Charging USB Type-A Device. GUID-20201029-CA0I-X7P9-9CRC-VWXGZXKRFBQ1-low.gif