SLVUCQ3 july   2023 TPS92621-Q1

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Test Setup
    2. 2.2 Connector Map
    3. 2.3 Jumper Map
  8. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layout
    3. 3.3 Bill of Materials (BOM)
  9. 4Additional Information
    1.     Trademarks

2.3 Jumper Map

The EVM provides some jumpers for designers to conveniently validate the device. Table 3-3 shows the jumper map.

Table 2-3 Jumper Map
Function Designator Attached Function With Shunt Without Shunt
Device enable J1 EN The device is enabled (EN connected to SUPPLY via a resistor) The device is disabled (EN floating)
PWM dimming input J2 PWM Enable PWM (PWM connected to SUPPLY via a resistor) Disable PWM or use external control signal
Fault option J3 FAULT One fails, others off Use external control signal
Open detect J4 LED open LED string connect to out LED string open
Short detect J5 Single LED short Short single LED in LED string 3 LED series in LED string
J6 LED string short Short all LEDs in LED string 3 LED series in LED string