SLVUCS3 October   2023

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Jumper Information
    2. 2.2 Test Points
  8. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials (BOM)
  9. 4Additional Information
    1. 4.1 Trademarks

2.2 Test Points

Table 3-3 shows the test points populated on the board as well as the signal connectors.

Table 2-3 Connections and Test Points
Connector and Test Point Description
J2, TP1 Supply Voltage VS.
J3, TP2 VDD voltage. Connect a supply if internal VDD is not used.
J4, TP3 Output voltage 1 (VOUT1).
J6, TP7 Output voltage 2 (VOUT2).
J7, TP9 Output voltage 3 (VOUT3).
J8, TP13 Output voltage 4 (VOUT4).
TP4, TP5, TP6, TP8, TP10, TP15, TP25, TP26, TP26, TP28, J5, J9 Ground.
TP11 ST1 Signal.
TP12 ST2 Signal.
TP17 ST3 Signal.
TP18 ST4 Signal.
TP14 REG_EN Signal.
TP16 DIA_EN Signal.
TP19 Latch Signal.
TP24 FAULT Signal.
TP20 EN1 Signal.
TP21 EN2 Signal.
TP22 EN3 Signal.
TP23 EN4 Signal.