SNLU271B March   2020  – June 2022 DP83TD510E

 

  1.   DP83TD510E-EVM User’s Guide
  2.   Trademarks
  3. 1Definitions
  4. 2Introduction
    1. 2.1 Key Features
    2. 2.2 Block Diagram
    3. 2.3 Board Setup Out of Box
  5. 3Board Setup Details
    1. 3.1 Power Supply Selection
      1. 3.1.1 Onboard Power Supply Operation
      2. 3.1.2 External Power Supply Operation
      3. 3.1.3 USB Power Supply Option
    2. 3.2 Clock Selection – DP83TD510E
      1. 3.2.1 50 MHz Reference Clock for DP83TD510E in RMII Slave Mode
      2. 3.2.2 Enable External Clock on DP83TD510E Board
      3. 3.2.3 Enable On-Board 25 MHz Crystal for DP83RD510E Board
      4. 3.2.4 Enable On-Board 25 MHz Crystal for DP83822 Board
      5. 3.2.5 50 MHz Reference Clock for DP83822 Board in RMII Slave Mode
    3. 3.3 SMI Connection
    4. 3.4 Cable Assembly
    5. 3.5 LED Indication
    6. 3.6 Serial Management Interface
    7. 3.7 Configuration Options
      1. 3.7.1 Bootstrap Options
  6. 4Software
    1. 4.1 MSP430 Driver
    2. 4.2 USB-2-MDIO Software
  7. 5USB to MDIO procedure
  8. 6Schematics
    1. 6.1 Main Power Schematic
    2. 6.2 Main Block Schematic
    3. 6.3 Interface Schematic
    4. 6.4 Analog Front End Schematic
    5. 6.5 COMs Schematic
    6. 6.6 Header Board
    7. 6.7 Hardware Schematic
  9. 7Layout
    1. 7.1  Top Overlay
    2. 7.2  Top Layer Mask
    3. 7.3  Top Layer
    4. 7.4  Ground Layer 1
    5. 7.5  Signal Layer
    6. 7.6  Power Layer
    7. 7.7  Ground Layer 2
    8. 7.8  Bottom Layer
    9. 7.9  Bottom Layer Mask
    10. 7.10 Bottom Overlay
    11. 7.11 Board Assembly
  10. 8Bill of Materials
  11. 9Revision History

4.2 USB-2-MDIO Software

Download the software from https://www.ti.com/tool/usb-2-mdio .

The web page also contains the User’s Guide for installing and using the software. Since the MSP430 is on-board the DP83TD510E-EVM, it is not necessary to purchase a separate MSP430 Launchpad kit and connect to the PHY using wires. In the case the on-board MSP430 cannot be used for some reason, MDIO and MDC pins are also broken out on J23 and J22 pins, respectively. Users can connect an MSP430 launchpad or their own MDIO-MDC utility on J23 and J22 to access the PHY.