SCES584C june   2005  – december 2022 SN74LVC8T245

PRODUCTION DATA  

  1. 1 Features
  2. 2 Applications
  3. 3 Description
  4. 4 Revision History
  5. 5 Pin Configuration and Functions
  6. 6 Specifications
    1. 6.1  Absolute Maximum Ratings
    2. 6.2  ESD Ratings
    3. 6.3  Recommended Operating Conditions
    4. 6.4  Thermal Information DB, DBQ and DGV
    5. 6.5  Thermal Information PW and RHL
    6. 6.6  Electrical Characteristics
    7. 6.7  Switching Characteristics, VCCA = 1.8 V ± 0.15 V
    8. 6.8  Switching Characteristics, VCCA = 2.5 V ± 0.2 V
    9. 6.9  Switching Characteristics, VCCA = 3.3 V ± 0.3 V
    10. 6.10 Switching Characteristics, VCCA = 5 V ± 0.5 V
    11. 6.11 Operating Characteristics
    12. 6.12 Typical Characteristics
  7. 7 Parameter Measurement Information
  8. 8 Detailed Description
    1. 8.1 Overview
    2. 8.2 Functional Block Diagram
    3. 8.3 Feature Description
      1. 8.3.1 Fully Configurable Dual-Rail Design Allows Each Port to Operate Over the Full 1.65-V to 5.5-V Power-Supply Range
      2. 8.3.2 Ioff Supports Partial-Power-Down Mode Operation
      3. 8.3.3 Balanced High-Drive CMOS Push-Pull Outputs
      4. 8.3.4 Vcc Isolation
    4. 8.4 Device Functional Modes
  9. 9 Application and Implementation
    1. 9.1 Application Information
    2. 9.2 Typical Application
      1. 9.2.1 Design Requirements
      2. 9.2.2 Detailed Design Procedure
      3. 9.2.3 Application Curve
  10. 10Power Supply Recommendations
  11. 11Layout
    1. 11.1 Layout Guidelines
    2. 11.2 Layout Example
  12. 12Device and Documentation Support
    1. 12.1 Receiving Notification of Documentation Updates
    2. 12.2 Support Resources
    3. 12.3 Trademarks
    4. 12.4 Electrostatic Discharge Caution
    5. 12.5 Glossary
  13. 13Mechanical, Packaging, and Orderable Information

Package Options

Mechanical Data (Package|Pins)
Thermal pad, mechanical data (Package|Pins)
Orderable Information

8.4 Device Functional Modes

The SN74LVC8T245 is voltage level translator that can operate from 1.65 V to 5.5 V (VCCA and VCCB). The signal translation between 1.65 V and 5.5 V requires direction control and output enable control. When OE is low and DIR is high, data transmission is from A to B. When OE is low and DIR is low, data transmission is from B to A. When OE is high, both output ports will be high-impedance. For voltage level translation below 1.65V, see TI AXC products.

Table 8-1 Function Table
(Each 8-Bit Section)
CONTROL INPUTS(1) OUTPUT CIRCUITS OPERATION
OE DIR A PORT B PORT
L L Enabled Hi-Z B data to A bus
L H Hi-Z Enabled A data to B bus
H X Hi-Z Hi-Z Isolation
(1) Input circuits of the data I/Os are always active.