SLUU367A July   2009  – February 2022 TPS51163

 

  1.   Trademarks
  2. 1 Introduction
  3. 2 Description
  4. 3 Typical Applications
  5. 4 Features
  6. 5 Electrical Performance Specifications
  7. 6 Schematic
  8. 7 Test Setup
    1. 7.1 Test Equipment
      1. 7.1.1 Voltage Source
      2. 7.1.2 Multimeters
      3. 7.1.3 Output Load
      4. 7.1.4 Oscilloscope
      5. 7.1.5 Fan
      6. 7.1.6 Recommended Wire Gauge
    2. 7.2 Recommended Test Setup
      1. 7.2.1 Input Connections
      2. 7.2.2 Output Connections
      3. 7.2.3 Other Connections
  9. 8 Test Procedure
    1. 8.1 Line/Load Regulation and Efficiency Measurement Procedure
    2. 8.2 Control Loop Gain and Phase Measurement Procedure
    3. 8.3 List of Test Points
    4. 8.4 Equipment Shutdown Procedure
  10. 9 Performance Data and Typical Characteristic Curves
  11. 10EVM Assembly Drawing and PCB layout
  12. 11List of Materials
  13. 12References
  14. 13Revision History

7.1.2 Multimeters

A voltmeter with a range between 0 V and 14 V should be used to measure VIN at TP1 (VIN) and TP2 (GND). A voltmeter with a range between 0 V and 5 V for VOUT measurement at TP6 (VOUT) and TP8 (GND). A current meter with a range between 0 A and 10 A (A1) as shown in Figure 7-2 is used for input current measurements.