SLUU367A
July 2009 – February 2022
TPS51163
Trademarks
1
Introduction
2
Description
3
Typical Applications
4
Features
5
Electrical Performance Specifications
6
Schematic
7
Test Setup
7.1
Test Equipment
7.1.1
Voltage Source
7.1.2
Multimeters
7.1.3
Output Load
7.1.4
Oscilloscope
7.1.5
Fan
7.1.6
Recommended Wire Gauge
7.2
Recommended Test Setup
7.2.1
Input Connections
7.2.2
Output Connections
7.2.3
Other Connections
8
Test Procedure
8.1
Line/Load Regulation and Efficiency Measurement Procedure
8.2
Control Loop Gain and Phase Measurement Procedure
8.3
List of Test Points
8.4
Equipment Shutdown Procedure
9
Performance Data and Typical Characteristic Curves
10
EVM Assembly Drawing and PCB layout
11
List of Materials
12
References
13
Revision History
7.2.2
Output Connections
Connect Load to J2 and set the load to constant resistance mode to sink 0 Adc before V
IN
is applied.
Connect a voltmeter V2 at TP6 (V
OUT
) and TP8 (GND) to measure the output voltage.