SLUUCV9 November   2023 TPS4800-Q1

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Setup
    2. 2.2 General Configurations
      1. 2.2.1 Physical Access
      2. 2.2.2 Test Equipment and Setup
        1. 2.2.2.1 Power Supplies
        2. 2.2.2.2 Meters
        3. 2.2.2.3 Oscilloscope
        4. 2.2.2.4 Loads
  8. 3Implementation Results
    1. 3.1 Test Setup and Procedures
      1. 3.1.1 Power-Up With EN Control
      2. 3.1.2 ON and OFF Control With INP Input
      3. 3.1.3 Overload and Short Circuit Protection Test
      4. 3.1.4 Overvoltage Protection Test
      5. 3.1.5 Short-Circuit Protection Diagnosis Test
      6. 3.1.6 Input Reverse Polarity Test
  9. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 PCB Layout
    3. 4.3 Bill Of Materials (BoM)
  10. 5Additional Information
    1.     Trademarks

PCB Layout

Figure 5-2 shows component placement of the EVAL Board, Figure 5-4 and Figure 5-6 show PCB layout images.

GUID-20231103-SS0I-D32J-GVJ0-CGSMT5Q6GKRC-low.svgFigure 4-2 TPS4800Q1EVM Board Top Overlay
GUID-20231103-SS0I-VFJG-J16D-ZLMVRMVVDG4Q-low.svgFigure 4-4 TPS4800Q1EVM Board Top Layer
GUID-20231103-SS0I-3XPC-8P2X-18HXFT9GVDN0-low.svgFigure 4-6 TPS4800Q1EVM Board Inner Signal Layer
GUID-20231103-SS0I-VMK7-CTNL-S8N264SQQ48K-low.svgFigure 4-3 TPS4800Q1EVM Board Bottom Overlay
GUID-20231103-SS0I-XC7H-Z1P4-KHVXFFC8NT46-low.svgFigure 4-5 TPS4800Q1EVM Board Bottom Layer
GUID-20231103-SS0I-WRGJ-M0CQ-QTVQWFPHXF9V-low.svgFigure 4-7 TPS4800Q1EVM Board Inner Routing Layer