15-14 |
RESERVED |
R |
0x0 |
|
13 |
LINKSTAT |
R |
0x0 |
Change of Link Status Interrupt. Reading this bit clears the interrupt and thus, the status bit.
0x0 = No change of link status.
0x1 = Change of link status interrupt is pending.
|
12 |
SPEED |
R |
0x0 |
Change of Speed Status Interrupt. Reading this bit clears the interrupt and thus, the status bit.
0x0 = No change of speed status.
0x1 = Change of speed status interrupt is pending.
|
11 |
DUPLEXM |
R |
0x0 |
Change of Duplex Status Interrupt. Reading this bit clears the interrupt and thus, the status bit.
0x0 = No change of duplex status.
0x1 = Duplex status change interrupt is pending.
|
10 |
ANC |
R |
0x0 |
Auto-Negotiation Complete Interrupt. Reading this bit clears the interrupt and thus, the status bit.
0x0 = No Auto-negotiation complete event is pending.
0x1 = Auto-negotiation complete interrupt is pending.
|
9 |
FCHF |
R |
0x0 |
False Carrier Counter Half-Full Interrupt. Reading this bit clears the interrupt and thus, the status bit.
0x0 = False carrier counter half-full event is not pending.
0x1 = False carrier counter (Register EPHYFCSCR) exceeds half-full and an interrupt is pending.
|
8 |
RXHF |
R |
0x0 |
Receive Error Counter Half-Full Interrupt. Reading this bit clears the interrupt and thus, the status bit.
0x0 = False carrier counter half-full event is not pending.
0x1 = Receive error counter (Register EPHYRXERCNT) exceeds half-full and an interrupt is pending.
|
7-6 |
RESERVED |
R |
0x0 |
|
5 |
LINKSTATEN |
R/W |
0x0 |
Link Status Interrupt Enable.
0x0 = Change of link status interrupt disabled.
0x1 = Enable interrupt on change of link status.
|
4 |
SPEEDEN |
R/W |
0x0 |
Speed Change Interrupt Enable.
0x0 = Change of speed status interrupt disabled.
0x1 = Enable interrupt on change of speed status
|
3 |
DUPLEXMEN |
R/W |
0x0 |
Duplex Status Interrupt Enable.
0x0 = Change of duplex status interrupt disabled.
0x1 = Enable interrupt on change of duplex status
|
2 |
ANCEN |
R/W |
0x0 |
Auto-Negotiation Complete Interrupt Enable.
0x0 = Auto-negotiation complete interrupt disabled.
0x1 = Enable interrupt on Auto-negotiation complete event
|
1 |
FCHFEN |
R/W |
0x0 |
False Carrier Counter Register half-full Interrupt Enable.
0x0 = False Carrier Counter Register half-full interrupt disabled.
0x1 = Enable interrupt on False Carrier Counter Register half-full event
|
0 |
RXHFEN |
R/W |
0x0 |
Receive Error Counter Register Half-Full Event Interrupt.
0x0 = Receive Error Counter Register half-full interrupt disabled.
0x1 = Enable interrupt on Receive Error Counter Register half-full event
|