TRF4140-Q1
- Benefits
- Full Embedded Sequence Timing Controller Removes All Timing Constraints From the Host Controller
- Automatic Sequence Repetition for Easy Implementation of Energy-Efficient Polling Systems
- Separate Transmit and Receive Buffers Reduce Host Controller Performance Requirements
- Embedded Sequence-Auto-Repeat Enables Low-Power Polling System Without Host Controller Interaction
- Embedded Half-Duplex (HDX) Protocol Support Enables Flexible and Scalable System Implementation
- Sine-Wave Controlled Transmitter Stages Enable High-Power Remote Antenna Systems With Cable Lengths of Several Meters and Superior EMC Performance
- Sequence Preloading With Event-Triggered Execution for Fastest System Reaction Time
- Features
- Integrated Boost Controller for Wide Supply Voltage Range With Jump Start and Load Dump Protection
- Antenna Driver With up to 20-V Peak-to-Peak Output Voltage Amplitude and up to 1-A Peak Antenna Current With Sine-Wave or Square-Wave Output
- Flexible Host Control Interface
- 4-Wire SPI
- Configurable I/O Functions to Extend Controller Interface Such as an Interrupt Request Signal
- Interface Voltage Supply Range From 2.5 V to 5.5 V
- Ultra-Low Current Consumption in Sleep State
- Fractional Synthesizer With 10-kHz to 500‑kHz Frequency Range With 60-Hz Step Size
- PSK and ASK Transmitter Stage
- FSK Receiver and Demodulator
- Four Programmable Half-Bridge MOSFET Antenna Drivers
- Pairs of Half-Bridge Antenna Drivers can be Used Together as a Full-Bridge Driver to Double the Possible Output Voltage Amplitude
- Antenna Current Measurement With 5-Bit Resolution for High Side and Low Side of Antenna Driver Stages
- Programmable Antenna Driver Output Voltage in Sine-Wave Mode
- Supply-Controlled Antenna Driver Voltage in Square-Wave Mode
- Output Stage is Overload Protected for Over-Current and Over-Temperature Conditions
- Antenna Driver Diagnostics: Short to Ground, Short to Antenna Driver Supply Voltage, and Open-Load Detection
- Supports On-Off Keying With Data Rates up to 70 kbps for Downlink and Uplink
The TRF4140-Q1 low-frequency (LF) transceiver base station device is intended for immobilizer and PEPS systems to communicate with LF transponders, remote keyless entry, and passive entry devices. The antenna driver stage consists of four MOSFET antenna drivers to send modulated LF transmissions and a receiver for detection and demodulation of LF transponder responses. The HDX communication scheme uses frequency shift keying (FSK) as the uplink modulation. The device can drive LF antennas to provide a wake-up and data sequence (PEPS), and it can also receive transponder responses on any or all channels (immobilizer).
The TRF4140-Q1 device needs VDD supply (5 V) for its control blocks and to feed the integrated logic voltage regulator. The antenna driver is supplied separately by VDDH (4 V to 20 V). This voltage can be used to generate a sine-wave output signal for superior EMC performance, which is important for remote antenna applications with several meters of antenna cable.
The TRF4140-Q1 device manages all timings required for a communication sequence without the need for an accurate host controller interaction. In conjunction with transmit and receive FIFOs, the host controller is off-loaded from all timing-critical events, which enables easy host controller process scheduling. In particular, the host controller start-up process for an automotive body control module is tremendously relaxed by this base station device.
The TRF4140-Q1 device supports sequence preloading and sequence execution on external events to start the immobilization process exactly when the key fob is detected. So, delays due to configuration can be avoided in inconvenient time frames.
更多資訊
索取完整產品規格表，勘誤及其他支援。經核准的使用者會在 1 -2 天內收到電子郵件。
技術文件
| 類型 | 標題 | 日期 | ||
|---|---|---|---|---|
| * | Data sheet | TRF4140-Q1 Abstract Low-Frequency Transceiver for Immobilizer, Passive Start, Passive Entry datasheet (Rev. B) | PDF | HTML | 2018年 10月 31日 |
| Product overview | Car access product family (Rev. A) | 2013年 9月 10日 | ||
| Product overview | Car access product family | 2012年 2月 21日 |
設計與開發
如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。
| 封裝 | 引腳 | 下載 |
|---|---|---|
| HTQFP (PHN) | 48 | 檢視選項 |
訂購與品質
- RoHS
- REACH
- 產品標記
- 鉛塗層/球物料
- MSL 等級/回焊峰值
- MTBF/FIT 估算值
- 材料內容
- 資格摘要
- 進行中可靠性監測
- 晶圓廠位置
- 組裝地點
建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。