SLVSJI0 November   2026 INA951-SP

PRODUCTION DATA  

  1.   1
  2. 1Features
  3. 2Applications
  4. 3Description
  5. 4Pin Configuration and Functions
  6. 5Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 Electrical Characteristics
    6. 5.6 Typical Characteristics
  7. 6Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Feature Description
      1. 6.3.1 Amplifier Input Common-Mode Signal
        1. 6.3.1.1 Input-Signal Bandwidth
        2. 6.3.1.2 Low Input Bias Current
        3. 6.3.1.3 Low VSENSE Operation
        4. 6.3.1.4 Wide Fixed Gain Output
        5. 6.3.1.5 Wide Supply Range
    4. 6.4 Device Functional Modes
      1. 6.4.1 Unidirectional Operation
      2. 6.4.2 High Signal Throughput
  8. 7Application and Implementation
    1. 7.1 Application Information
      1. 7.1.1 RSENSE and Device Gain Selection
      2. 7.1.2 Input Filtering
    2. 7.2 Typical Application
      1. 7.2.1 Design Requirements
      2. 7.2.2 Detailed Design Procedure
        1. 7.2.2.1 Overload Recovery With Negative VSENSE
      3. 7.2.3 Application Curve
    3. 7.3 Power Supply Recommendations
    4. 7.4 Layout
      1. 7.4.1 Layout Guidelines
      2. 7.4.2 Layout Example
  9. 8Device and Documentation Support
    1. 8.1 Receiving Notification of Documentation Updates
    2. 8.2 Support Resources
    3. 8.3 Trademarks
    4. 8.4 Electrostatic Discharge Caution
    5. 8.5 Glossary
  10. 9Mechanical, Packaging, and Orderable Information

Refer to the PDF data sheet for device specific package drawings

Wide Fixed Gain Output

The INA951-SP gain error is < 0.15% at room temperature, with a maximum drift of 10ppm/°C over the full temperature range of –55°C to +125°C. The INA951-SP is available in a gain option of 20V/V.

The INA951-SP closed-loop gain is set by a precision, low drift internal resistor network. The ratio of these resistors are excellently matched, while the absolute values can vary significantly. Adding additional resistance around the INA951-SP to change the effective gain is not recommended, however, because of this variation. The typical values of the gain resistors are described in Table 6-1.

Table 6-1 Fixed Gain Resistor
GAIN R1 RL
20(V/V) 25kΩ 500kΩ