SCBS881E January   2010  – October 2018 TMS3705

PRODUCTION DATA.  

  1. 1Device Overview
    1. 1.1 Features
    2. 1.2 Applications
    3. 1.3 Description
    4. 1.4 Functional Block Diagram
  2. 2Revision History
  3. 3Device Characteristics
    1. 3.1 Related Products
  4. 4Terminal Configuration and Functions
    1. 4.1 Pin Diagram
    2. 4.2 Signal Descriptions
      1. Table 4-1 Signal Descriptions
  5. 5Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Electrical Characteristics
    5. 5.5 Thermal Resistance Characteristics for D (SOIC) Package
    6. 5.6 Switching Characteristics
    7. 5.7 Timing Diagrams
  6. 6Detailed Description
    1. 6.1  Power Supply
    2. 6.2  Oscillator
    3. 6.3  Predrivers
    4. 6.4  Full Bridge
    5. 6.5  RF Amplifier
    6. 6.6  Band-Pass Filter and Limiter
    7. 6.7  Diagnosis
    8. 6.8  Power-on Reset
    9. 6.9  Frequency Divider
    10. 6.10 Digital Demodulator
    11. 6.11 Transponder Resonance-Frequency Measurement
    12. 6.12 SCI Encoder
    13. 6.13 Control Logic
    14. 6.14 Test Pins
  7. 7Applications, Implementation, and Layout
    1. 7.1 Application Diagram
  8. 8Device and Documentation Support
    1. 8.1 Getting Started and Next Steps
    2. 8.2 Device Nomenclature
    3. 8.3 Tools and Software
    4. 8.4 Documentation Support
    5. 8.5 Community Resources
    6. 8.6 Trademarks
    7. 8.7 Electrostatic Discharge Caution
    8. 8.8 Export Control Notice
    9. 8.9 Glossary
  9. 9Mechanical, Packaging, and Orderable Information

Package Options

Mechanical Data (Package|Pins)
Thermal pad, mechanical data (Package|Pins)
Orderable Information

Full Bridge

The full bridge drives the antenna current at the carrier frequency during the charge phase and the active time of the write phase. The minimal load resistance the full bridge sees between its outputs in normal operation at the resonance frequency of the antenna is 43.3 Ω. When the full bridge is not active, the two driver outputs are switched to ground.

Both outputs of the full bridge are protected independently against short circuits to ground.

In case of an occurring short circuit, the full bridge is switched off in less than 10 µs to avoid a drop of the supply voltage. After a delay time of less than 10 ms the full bridge is switched on again to test if the short circuit is still there. An overcurrent due to a resistive short to ground that is higher than the maximum current in normal operation but lower than the current threshold for overcurrent protection does not need to be considered.