SBVS460 July 2025 TPS7C13
PRODUCTION DATA
For this design example, VOUT is set to 3.3V. The following equations set the feedback divider resistors for the desired output voltage:
For improved output accuracy, use Equation 7 and IFB = 100nA as listed in the Electrical Characteristics table to calculate the upper limit for series feedback resistance (R1 + R2 ≤ 330kΩ).
The control-loop error amplifier drives the FB pin to the same voltage as the internal reference (VFB = 0.6V, as listed in the Electrical Characteristics table). Use Equation 6 to determine the ratio of R1 / R2 = 4.5. Use this ratio and solve Equation 7 for R1. Now calculate the upper limit for R1 ≤ 270kΩ. Select a standard value resistor for R1 = 267kΩ.
Reference Equation 6 and solve for R2:
From Equation 8, R2 = 59kΩ is determined. Select a standard value resistor for R2 = 59kΩ. VOUT = 3.3V (as determined by Equation 6). Verify that the feedback divider current is greater than the minimum value in the Recommended Operating Conditions table.
The following equation calculates the feedback divider current.