SLUSCV8B April 2017 – November 2026 UCC20225
PRODUCTION DATA
The bootstrap capacitor is charged by VDD through an external bootstrap diode every cycle when the low side transistor turns on. Charging the capacitor involves high-peak currents, and therefore transient power dissipation in the bootstrap diode can be significant. Conduction loss also depends on the forward voltage drop of the diode. Both the diode conduction losses and reverse recovery losses contribute to the total losses in the gate driver circuit.
When selecting external bootstrap diodes, it is recommended that one chose high voltage, fast recovery diodes or SiC Schottky diodes with a low forward voltage drop and low junction capacitance to minimize the loss introduced by reverse recovery and related grounding noise bouncing. In the example, the DC-link voltage is 800VDC. The voltage rating of the bootstrap diode must be higher than the DC-link voltage with a good margin. Therefore, a 600V ultrafast diode, MURA160T3G, is selected in this example.
A bootstrap resistor, RBOOT, is used to reduce the inrush current in DBOOT and limit the ramp-up slew rate of voltage of VDDA-VSSA during each switching cycle, especially when the VSSA(SW) pin has an excessive negative transient voltage. The recommended value for RBOOT is from 1Ω to 20Ω depending on the diode used. In the example, a current limiting resistor of 2.7Ω is selected to limit the inrush current of bootstrap diode. The estimated worst-case peak current through DBoot is,

where