JAJSUB2 データシート

JAJSUB2E August 1990 – April 2024 SN75ALS172A

PRODUCTION DATA

パッケージ・オプション

デバイスごとのパッケージ図は、PDF版データシートをご参照ください。

メカニカル・データ（パッケージ｜ピン）

N|16
DW|20

サーマルパッド・メカニカル・データ

発注情報

5.5 Electrical Characteristics

over recommended ranges of supply voltage and operating free-air temperature (unless otherwise noted)

PARAMETER		TEST CONDITIONS			MIN	TYP ⁽¹⁾	MAX	UNIT
V_IK	Input clamp voltage	I_I = -18mA					-1.5	V
V_O	Output voltage	I_O = 0			0		6	V
\|V_OD1\|	Differential output voltage	I_o = 0			1.5		6	V
\|V_OD2\|	Differential output voltage	V_CC = 5V,	R_L = 100Ω,	See Figure 6-1	1/2V_OD1 or 2⁽²⁾			V
\|V_OD2\|	Differential output voltage	R_L = 54Ω,	See Figure 6-1		1.5	2.5	5	V
\|V_OD3\|	Differential output voltage	See ^{Note 2}			1.5		5	V
Δ\|V_OD\|	Change in magnitude of differential output voltage^⁽³⁾	R_L = 54Ω or 100Ω,	See Figure 6-1				±0.2	V
V_OC	Common-mode output voltage^⁽⁴⁾	R_L = 54Ω or 100Ω,	See Figure 6-1		-1		3	V
Δ\|V_OC\|	Change in magnitude of common-mode output voltage^⁽³⁾	R_L = 54Ω or 100Ω,	See Figure 6-1				±0.2	V
I_O	Output current with power off	V_CC = 0,	V_O = -7V to 12V				±100	μA
I_OZ	High-impedance-state output current	V_O = -7V to 12V					±100	μA
I_IH	High-level input current	V_I = 2.7V					20	μA
I_IL	Low-level input current	V_I = 0.4V					-100	μA
I_OS	Short-circuit output current	V_O = -7V to 12V					±250	mA
I_CC	Supply current (all drivers)	No load	Outputs enabled			36	55	mA
I_CC	Supply current (all drivers)	No load	Outputs disabled			15	30	mA

(1) All typical values are at V_CC = 5V and T_A = 25°C.

(2) The minimum V_OD2 with a 100Ω load is either 1/2 V_OD1 or 2V, whichever is greater.

(3) ∆|V_OD| and ∆|V_OC| are the changes in magnitude of V_OD and V_OC, respectively, that occur when the input is changed from a high level to a low level.

(4) In ANSI Standard EIA/TIA-422-B, V_OC, which is the average of the two output voltages with respect to ground, is called output offset voltage, V_OS.

(5) See EIA Standard RS-485, Figure 6-3-5, Test Termination Measurement 2.