SLAU892A March   2023  – June 2024

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  6. 2Hardware
    1. 2.1 Hardware Setup
      1. 2.1.1 Electrostatic Discharge Caution
      2. 2.1.2 Power Configurations and Jumper Settings
      3. 2.1.3 Connecting the Hardware
    2. 2.2 Hardware Description
      1. 2.2.1 Theory of Operation
        1. 2.2.1.1 Signal Definitions
  7. 3Software
    1. 3.1 Software Setup
      1. 3.1.1 Operating Systems
      2. 3.1.2 Software Installation
    2. 3.2 Software Description
      1. 3.2.1 Starting the Software
      2. 3.2.2 Software Features
        1. 3.2.2.1 High Level Configuration Page
          1. 3.2.2.1.1 DACs Subpage
          2. 3.2.2.1.2 ADCs Subpage
          3. 3.2.2.1.3 Alarms Subpage
          4. 3.2.2.1.4 GPIO + Temp Subpage
        2. 3.2.2.2 Low Level Configuration Page
  8. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layout
    3. 4.3 Bill of Materials
  9. 5Additional Information
    1. 5.1 Trademarks
  10. 6Related Documentation from Texas Instruments
  11. 7Revision History

2.1.3 Connecting the Hardware

After the power and jumper configurations are set up as per Section 2.1.2 , connect the USB cable from the AFE11612EVM USB port to the computer.