SLVU346A January   2010  – February 2022 TPS51218

 

  1.   Trademarks
  2. 1Description
    1. 1.1 Typical Applications
    2. 1.2 Features
  3. 2Electrical Performance Specifications
  4. 3Schematic
  5. 4Test Setup
    1. 4.1 Test Equipment
    2. 4.2 Recommended Test Setup
      1. 4.2.1 Configurations
      2. 4.2.2 Input Connections
      3. 4.2.3 Output Connections
      4. 4.2.4 Other Connections
  6. 5Test Procedure
    1. 5.1 Line/Load Regulation and Efficiency Measurement Procedure
    2. 5.2 List of Test Points
    3. 5.3 Equipment Shutdown
  7. 6Performance Data and Typical Characteristic Curves
    1. 6.1 Efficiency
    2. 6.2 Load Regulation
    3. 6.3 Transient Response
    4. 6.4 Output Ripple
    5. 6.5 Switch Node Voltage
    6. 6.6 Turn-On Waveform
    7. 6.7 Turn-Off Waveform
    8. 6.8 Output 1.1-V Prebias Turn-On
  8. 7EVM Assembly Drawing and PCB Layout
  9. 8Bill of Materials
  10. 9Revision History

Output Connections

  1. Connect the load to J2, and set the load to constant resistance mode to sink 0 ADC before VIN is applied.
  2. Connect a voltmeter V2 at TP8 (VOUT) and TP9 (PGND) to measure the output voltage.