SDAA320 June   2026 AM625 , AM625SIP , AM62D-Q1 , AM62L , AM62P

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1 Introduction
    1. 1.1 Key Highlights:
    2. 1.2 Basic Concepts:
      1. 1.2.1 PipeWire Server
      2. 1.2.2 PipeWire Clients
      3. 1.2.3 Session Manager
      4. 1.2.4 Nodes, Ports, and Links
    3. 1.3 PipeWire Main Components
  5. 2 Linux Audio Stack
  6. 3 Build SDK Image with PipeWire Support via Yocto
    1. 3.1 Steps to Run Yocto Builds on Host
      1. 3.1.1 Prerequisites (One-time setup)
    2. 3.2 Clone the oe-layer Setup
    3. 3.3 Download and Apply PipeWire Patches
    4. 3.4 Build PipeWire Image
  7. 4 Setup PipeWire on Sitara Devices
    1. 4.1 Hardware
      1. 4.1.1 SK-AM62B-P1
      2. 4.1.2 TMDS62LEVM
      3. 4.1.3 AUDIO-AM62D-EVM
    2. 4.2 Configure EVM Boot Mode
      1. 4.2.1 SK-AM62B-P1
      2. 4.2.2 TMDS62LEVM
      3. 4.2.3 AUDIO-AM62D-EVM
    3. 4.3 UART Console Setup
    4. 4.4 Flash the SD Card Image
    5. 4.5 Booting EVM with SD Card
  8. 5 Use PipeWire
    1. 5.1 Check Service Status
    2. 5.2 Enable PipeWire and Wireplumber
    3. 5.3 Start PipeWire and WirePlumber
    4. 5.4 General PipeWire commands
      1. 5.4.1 List All Objects Currently in PipeWire Server
      2. 5.4.2 List Only Nodes
      3. 5.4.3 Inspect Specific Object
    5. 5.5 Play and Record Stereo Audio
  9. 6 Configuration
    1. 6.1 Sink and Source Configuration
    2. 6.2 WirePlumber Configuration
  10. 7 Performance Benchmarks
    1. 7.1 Latency
    2. 7.2 CPU and Memory Usage
    3. 7.3 CPU and Memory Usage with Resampling
    4. 7.4 Observations
  11. 8 Summary
  12. 9 References
  13. 10IMPORTANT NOTICE AND DISCLAIMER

UART Console Setup

  • Connect UART to USB cable to EVM.
  • Identify the UART COM port as enumerated on the host machine (Windows Device Manager Ports (COM & LPT)).
  • If there are no USB serial ports listed in Device Manager under Ports (COM & LPT), then install the UART to USB driver from FTDI.
  • Terminal Settings
    • Baud Rate: 115200
    • 8-N-1
  • Open Terminal and wait for device to boot.