SLAU968 December   2025

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Power Requirements
    2. 2.2 Setup
    3. 2.3 Jumper Information
    4. 2.4 PMBus Address Configuration
    5. 2.5 Header Information
    6. 2.6 Push Buttons
    7. 2.7 Interfaces
    8. 2.8 Debug Information
    9. 2.9 Test Points
  8. 3Software
    1. 3.1 Software Description
    2. 3.2 GUI Installation
    3. 3.3 Programming Options
  9. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  10. 5Additional Information
    1. 5.1 Trademarks
  11. 6Related Documentation
    1. 6.1 Supplemental Content
  12. 7References
  13.   Revision History

2.6 Push Buttons

The only push button available on this device is SW1. The SW1 push button is used to reset the UCD91320 device. Note that the RST signal is active low.