SLUUCT5 October   2023

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Additional Images
    2. 2.2 Hardware Description
      1. 2.2.1 I/O Description
  9. 3Implementation Results
    1. 3.1 Electrical Specifications
    2. 3.2 Test Summary
      1. 3.2.1 Definitions
      2. 3.2.2 Equipment
        1. 3.2.2.1 Power Supply
        2. 3.2.2.2 Function Generator
        3. 3.2.2.3 DMM
        4. 3.2.2.4 Oscilloscope
      3. 3.2.3 Equipment Setup
        1. 3.2.3.1 DC Power Supply Settings
        2. 3.2.3.2 Digital Multi-Meter Settings
        3. 3.2.3.3 Two-Channel Function Generator Settings
        4. 3.2.3.4 29
        5. 3.2.3.5 Oscilloscope Settings
        6. 3.2.3.6 Bench Setup Diagram
    3. 3.3 Power Up and Power Down Procedure
      1. 3.3.1 Power Up
      2. 3.3.2 Power Down
    4. 3.4 Typical Performance Waveforms (CL = 1800 pF)
      1. 3.4.1 Propagation Delays
  10. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials
  11. 5Additional Information
    1.     Trademarks

3.4.1 Propagation Delays

The following waveforms illustrate the IN input and OUT output.

To evaluate propagation delays and rising and falling details, TI recommends to have scope probe connections with short ground leads.

GUID-20230927-SS0I-XT8R-WPFC-PZWXQFNVMNMJ-low.png Figure 3-3 Rise Time and Rising Propagation Delay
Note: To evaluate data sheet timing parameters, change C6 to 10 nF.
GUID-20230927-SS0I-1TRS-LCMX-DHDQGDJ8RM3R-low.png Figure 3-4 Fall Time and Falling Propagation Delay
Note: To evaluate data sheet timing parameters, change C6 to 10 nF.