SLUUCZ9D January   2024  – February 2025

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Device Information
      1. 1.3.1 U1 Component Selection
      2. 1.3.2 UCC33420-Q1 Pin Definition
    4. 1.4 Specification
  7. 2Hardware
    1. 2.1 EVM Setup and Operation
      1. 2.1.1 Recommended Test Equipment
      2. 2.1.2 External Connections for Easy Evaluation
      3. 2.1.3 Powering the EVM
      4. 2.1.4 EVM Test Points
      5. 2.1.5 Oscilloscope Probes: Probing the EVM
  8. 3Implementation Results
    1. 3.1 Schematic
    2. 3.2 Performance Data
      1. 3.2.1 Efficiency Data
      2. 3.2.2 Regulation Data
      3. 3.2.3 Startup Waveforms
      4. 3.2.4 Inrush Current
      5. 3.2.5 AC Ripple Voltage
      6. 3.2.6 Load Transient
      7. 3.2.7 VCC Short-Circuit
      8. 3.2.8 Thermal Performance
  9. 4Hardware Design Files
    1. 4.1 Assembly and Printed Circuit Board (PCB)
    2. 4.2 Bill of Materials (BOM)
  10. 5Additional Information
    1. 5.1 Trademarks
  11. 6Revision History

3.2.7 VCC Short-Circuit

Short circuit is applied with an electronic load. FLT pin is pulled down during 200μs and the device tries to restart after 160ms as shown in the waveform below. Device restarts successfully after short circuit is released.

UCC33420Q1-EVM UCC33420-Q1 Short Circuit, VINP=5.0V, VCC=5.0V Figure 3-32 UCC33420-Q1 Short Circuit, VINP=5.0V, VCC=5.0V
UCC33420Q1-EVM UCC33410-Q1 Short Circuit, VINP=5.0V, VCC=3.3V Figure 3-33 UCC33410-Q1 Short Circuit, VINP=5.0V, VCC=3.3V
UCC33420Q1-EVM UCC33020-Q1 Short Circuit, VINP=3.3V, VCC=5.0V Figure 3-34 UCC33020-Q1 Short Circuit, VINP=3.3V, VCC=5.0V