SLUUD47 October   2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 EVM Setup
    2. 2.2 EVM Connectors and Test Points
    3. 2.3 Testing Procedures
      1. 2.3.1 Equipment
      2. 2.3.2 Charge Mode
      3. 2.3.3 Ship Mode
  9. 3Hardware Design Files
    1. 3.1 Schematic
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials
  10. 4Additional Information
    1. 4.1 Trademarks

2.2 EVM Connectors and Test Points

The default configuration for connectors is shown in Table 2-2.

Table 2-2 Factory Jumper Settings
Jumper NameDescriptionSetting
J1I2C pullup

NA

J2VIN and GND connectorNA
J3VBAT and GND connectorNA
J4Battery pack connectorNA
J5TS potentiometer connectorConnected
J6USB2ANY connectorNA
J7VIO connector to 3p3VNA
J8, J9Board connector to other modulesNA
J10/INT connector to 3p3VConnect 3p3V to /INT
J11VSYS and GND connectorNA
J14Micro-USB connector (optional for VIN)NA
Note: Connecting the J7 jumper enables the VIO LED. This LED draws 10mA.