SLVUC40 May   2021 TPS629210-Q1

 

  1.   Trademarks
  2. 1Introduction
  3. 2Performance Specification
  4. 3EVM Configuration and Modification
    1. 3.1 Input and Output Capacitors
    2. 3.2 Configurable Enable Threshold Voltage
    3. 3.3 MODE/S-CONF Setting
    4. 3.4 Power Good
    5. 3.5 Power Good Pull Up Voltage
    6. 3.6 Feedforward Capacitor Option
    7. 3.7 Output Voltage Setting
    8. 3.8 Loop Response Measurement
  5. 4EVM Test Set Up
    1. 4.1 Input and Output Connectors
    2. 4.2 Jumper Configuration
      1. 4.2.1 JP1 Enable
      2. 4.2.2 JP2 MODE/S-CONF
      3. 4.2.3 JP3 Power Good
      4. 4.2.4 JP4 PG Pull Up Voltage
  6. 5Test Results
  7. 6Board Layout
  8. 7Schematic and Bill of Materials
    1. 7.1 Schematic
    2. 7.2 Bill of Materials
  9. 8References

4.1 Input and Output Connectors

Table 4-1 Input and Output Connector
Connector Pins Description
J1 Pin1 and Pin2 VIN positive input for input supply.
Pin3 and Pin4 S+ and S- input voltage sense. Input voltage measure point.
Pin5 and Pin6 GND return for input supply.
J2 Pin1 and Pin2 VOUT Output voltage connection.
Pin3 and Pin4 S+ and S- output voltage sense. Output voltage measure point.
Pin5 and Pin6 GND Output return connection.