SLYU064A June   2023  – December 2023 TMAG3001 , TMAG5170 , TMAG5170-Q1 , TMAG5170D-Q1 , TMAG5173-Q1 , TMAG5253 , TMAG5273

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Introduction
  5. 2Joystick Design
    1. 2.1 Establishing Form Factor
      1. 2.1.1 Choosing Mechanical Implementation
      2. 2.1.2 Choosing Magnetic Implementation
    2. 2.2 Magnet Sensor Placement
    3. 2.3 Design Calculations
    4. 2.4 Post Processing
    5. 2.5 Prototyping and Bench Testing
    6. 2.6 Error Sources
      1. 2.6.1 Mechanical Hysteresis
      2. 2.6.2 Nearby Material Influence
      3. 2.6.3 Fulcrum Slippage
      4. 2.6.4 Offset
  6. 3Lever Design
    1. 3.1 Establishing a Form Factor
      1. 3.1.1 Choosing Mechanical Implementation
    2. 3.2 Magnet Sensor Placement
    3. 3.3 Design Calculations
    4. 3.4 Prototyping and Bench Testing
    5. 3.5 Error Sources
  7. 4Summary
  8. 5References
  9. 6Revision History

2.6.4 Offset

Offset corresponds to the magnet not being centered properly over the device sensing element, indicated by the blue box in Figure 2-25. Offset along the y-axis as defined in Figure 2-25, is not as bad as offset along the x-axis or z-axis. Increasing the offset along the z-axis decreases the field strength measure by the device. Whereas offset along the x-axis shifts the field characteristic and decreases the usable linear range.

GUID-20230512-SS0I-XN8F-ZX17-QD98W4SQK1W4-low.svg Figure 2-25 Magnet Rotating in Device zx Plane