SWRU602 September   2023 CC3300 , CC3301

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Acronyms
  5. 2Prerequisites
  6. 3Calibrator Tool Commands
    1. 3.1 Enable PLT Mode
    2. 3.2 Tune Channel
    3. 3.3 Transmit Chain Parameters
      1. 3.3.1 TX Parameters
      2. 3.3.2 TX Trigger-Based Parameters
      3. 3.3.3 TX Tone Start and Stop
      4. 3.3.4 Example TX Commands
    4. 3.4 Receive Chain Parameters
      1. 3.4.1 Enable/Start RX Statistics Test
      2. 3.4.2 Disable/Stop RX Statistics Test
  7.   A Set_TX Default Parameters

3.4.2 Disable/Stop RX Statistics Test

The following command will stop the RX statistics test. It is crucial to finish the test with this command:

calibrator wlan0 cc33xx_plt stop_rx