SWRU631 November   2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 PCB Handling Recommendations
    2. 2.2 Power Connections
    3. 2.3 Connectors
      1. 2.3.1 MIPI 60-Pin Connector (J19)
        1. 2.3.1.1 MIPI TRACE ECO List
      2. 2.3.2 Debug Connector-60 pin (J7)
        1. 2.3.2.1 CSI2 FE Connector ECO List
      3. 2.3.3 Ethernet Ports (J4 and J9)
        1. 2.3.3.1 ECOs to Enable the DP83TG720S-Q1 PHY
      4. 2.3.4 USB Connectors (J8, J10)
      5. 2.3.5 OSC_CLK_OUT Connector (J2)
      6. 2.3.6 Voltage Rails Ripple Measurement Connectors (J1, J3, J5) (DNP)
    4. 2.4 Antenna
    5. 2.5 PMIC
    6. 2.6 On-Board Sensors
    7. 2.7 PC Connection
      1. 2.7.1 XDS110 Interface
      2. 2.7.2 FTDI Interface
    8. 2.8 Connecting the AWR2E44PEVM to the DCA1000 EVM
    9. 2.9 Jumpers, Switches, and LEDs
      1. 2.9.1 Switches
      2. 2.9.2 Sense On Power (SOP) Jumpers (J17, J18, J20)
      3. 2.9.3 I2C Connections
      4. 2.9.4 Push Buttons
      5. 2.9.5 LEDs
  8. 3Software
    1. 3.1 Software, Development Tools, and Example Code
  9. 4Hardware Design Files
    1. 4.1 Design Files
  10. 5Additional Information
    1.     Trademarks
  11. 6Revision History

2.7.1 XDS110 Interface

J8 provides access to the onboard XDS110 (TM4C1294NCPDT) emulator. This connection provides the following interfaces to the PC:

  • JTAG for CCS connectivity
  • MSS logger UART (can be used to get MSS code logs on the PC)

When the J8 USB is connected to the PC the device manager should recognize two XDS110 COM ports under Ports (COM & LPT).

AWR2E44PEVM XDS110 COM PortsFigure 2-15 XDS110 COM Ports

XDS110 debug probe and data port are detected under Texas Instruments Debug Probes.

AWR2E44PEVM TI Debug ProbesFigure 2-16 TI Debug Probes

If the PC is unable to recognize the above COM ports, install the latest EMUpack.