TIDUEX8 September   2020

 

  1.   Description
  2.   Resources
  3.   Features
  4.   Applications
  5.   5
  6. 1System Description
    1. 1.1 Key System Specifications
  7. 2System Overview
    1. 2.1 Block Diagram
    2. 2.2 Highlighted Products
      1. 2.2.1 TPS23730
      2. 2.2.2 TLV431
    3. 2.3 System Design Theory
      1. 2.3.1 IEEE802.3bt Introduction
  8. 3Hardware, Testing Requirements, and Test Results
    1. 3.1 Required Hardware
      1. 3.1.1 Hardware
    2. 3.2 Testing and Results
      1. 3.2.1 Test Setup
      2. 3.2.2 Test Results
        1. 3.2.2.1 Efficiency
        2. 3.2.2.2 Control Loop Gain/Stability
        3. 3.2.2.3 Load Transient
        4. 3.2.2.4 Input and Output Ripple
        5. 3.2.2.5 Switching Waveforms
        6. 3.2.2.6 Start Up Response
        7. 3.2.2.7 Soft-Stop Response
        8. 3.2.2.8 Output Short Circuit Response
        9. 3.2.2.9 Thermal Performance
  9. 4Design Files
    1. 4.1 Schematics
    2. 4.2 Bill of Materials
    3. 4.3 PCB Layout Recommendations
      1. 4.3.1 Layout Prints
    4. 4.4 Altium Project
    5. 4.5 Gerber Files
    6. 4.6 Assembly Drawings
  10. 5Related Documentation
    1. 5.1 Trademarks
  11. 6Terminology
  12. 7About the Author

3.2.1 Test Setup

The jumpers and connectors configurations are shown in Table 3-2.

Table 3-2 TIDA Jumper and Connector Configuration
TYPELABELJUMPER/CONNECTORVALUE
InputEthernet PowerJ1Open
Ethernet DataJ2Power supply with voltage from 37-V to 57-V
Adaptor InputJ3Open for PoE tests. Connected to 37-V to 57-V power supply for adaptor tests
PD ConfigurationAPD_ConnectJ4Connected to pins 2 & 3

PPD

J5Open
DTHRJ8

Connected

EMPSJ9Connected
SCDISJ10Open
TPH / TPL / BT OutputJ11Connected to pins 1 & 2 for LED's
OutputVOUTJ11Connected to electronic load. At full load, resistor load is 0.1 Ω.