ADTEC-3P-FORCESENSOR

ADTEC-3P-FORCESENSOR

From: AD-TEC GmbH
Order now

Overview

force sensor permanently magnetizes the structural load-bearing element and measures the magnetomechanical field response to applied force without contact, eliminating strain gauges, adhesives and mechanical wear mechanisms. Applications include press and forming force monitoring, load cell replacement in harsh or high-temperature environments, crane and lifting equipment load measurement, rehabilitation and patient handling devices, and multiaxis force measurement in test and measurement benches. The solution operates at a maximum 47kHz analog bandwidth and is built on a full TI silicon stack including the MSPM0 microcontroller for signal processing and digital output.

Features
  • Contactless force measurement compression, tension and multiaxis loading
  • Non-contact no strain gauges, no surface preparation, no adhesive bonding
  • Load cell replacement in harsh, high-temperature or high-cycle environments
  • Up to 47kHz analog bandwidth static and dynamic force events captured in real time
  • Applications: press monitoring, crane and lifting load, test and measurement benches
  • Evaluation kit: 25mm steel cube + sensor PCB + readout that works with any press or vice
Analog temperature sensors
TMP236 — ±2.0°C analog output temperature sensor, with 19.5mV/°C gain

 

General-purpose MCUs
MSPM0C1106 — 32MHz Arm® Cortex®-M0+ MCU with 64KB flash, 8KB SRAM, 12-bit ADC, comparator, advanced timer

 

General-purpose op amps
TLV9062 — Dual, 5.5-V, 10-MHz operational amplifier

 

Linear & low-dropout (LDO) regulators
LP5907 — 250-mA, low-noise, high-PSRR, ultra-low-dropout voltage regulator with low IQ and enable

 

Shunt voltage references
TL431 — Adjustable precision shunt regulator

 

Signal conditioners
DRV425 — Fully-integrated fluxgate magnetic sensor for open-loop applications
Download View video with transcript Video
Photos courtesy of AD-TEC GmbH

Order & start development

Third-party accessory

ADTEC-FS-0025-EVAL — AD-TEC force sensor evaluation kit

Supported products & hardware

ADTEC-FS-0025-EVAL — AD-TEC force sensor evaluation kit

close
Version: null
Release date:
TI's Standard Terms and Conditions for Evaluation Items apply.

Support & training

Third-party support
TI does not offer ongoing direct design support for this hardware. For support while working through your design, contact AD-TEC GmbH.

Videos

Disclaimer

Certain information and resources (including links to non-TI sites) above may be provided by a third-party partner, and is included here merely for your convenience. TI is not the provider of, and is not responsible for, the content of such information and resources, and you should evaluate them carefully for your intended uses and on your own behalf. The inclusion of such information and resources here does not imply endorsement of any third-party company by TI, and shall not be construed as a warranty or representation regarding the suitability of any third-party products or services, either alone or in combination with any TI product or service.