SBAU408 august   2023 ADS7953

 

  1.   1
  2.   ADS7953EVM-PDK Evaluation Module
  3.   Trademarks
  4. 1Overview
    1. 1.1 ADS7953EVM-PDK Features
    2. 1.2 ADS7953EVM Features
  5. 2Analog Interface
    1. 2.1 Connectors for Analog Inputs
    2. 2.2 ADC Input Signal Driver
      1. 2.2.1 Input Signal Path
  6. 3Digital Interfaces
    1. 3.1 SPI for the ADC Digital I/O
  7. 4Power Supplies
    1. 4.1 ADC Voltage Reference Configuration
  8. 5ADS7953EVM-PDK Initial Setup
    1. 5.1 Default Jumper Settings
    2. 5.2 EVM Graphical User Interface Software Installation
  9. 6ADS7953EVM-PDK Operation
    1. 6.1 EVM GUI Global Settings for ADC Control
    2. 6.2 Time Domain Display Tool
    3. 6.3 Spectral Analysis Tool
    4. 6.4 Histogram Analysis Tool
    5. 6.5 Device Configuration
    6. 6.6 Alarm Configuration
  10. 7Schematic, Bill of Materials, and Printed-Circuit Board Layout
    1. 7.1 Schematic
    2. 7.2 Bill of Materials
    3. 7.3 PCB Layout

5.1 Default Jumper Settings

Figure 5-1 details the jumper locations for the ADS7953EVM-PDK.

GUID-20230512-SS0I-F7JC-LQPM-PHCFDLHDTCX9-low.svgFigure 5-1 Default Jumper Settings

Table 5-1 lists the functionality and default configuration of each jumper.

Table 5-1 Default Jumper Configurations
Reference Designator Default Configuration Description
JP1 and JP3 1-2 Amplifiers are used in this position.
Place jumper on pins 2-3 on JP1 or JP3 to bypass the amplifier in the circuit.
JP2 1-2 Onboard +VA supply is used in this position.
Place the jumper in position 2-3 to connect an external supply.
JP4 1-2 Onboard reference is used in this position.
Place the jumper in position 2-3 to connect an external reference.