SPRUJ93 august   2023

1.   1
2.   Description
3.   Features
4.   4
5. 1Evaluation Module Overview
   1.     Preface: Read This First
      1. 1.1.1 Sitara™ MCU+ Academy
      2. 1.1.2 If You Need Assistance
      3. 1.1.3 Important Usage Notes
   2. 1.1 Introduction
   3. 1.2 Kit Contents
   4. 1.3 Specification
   5. 1.4 Device Information
   6. 1.5 HSEC 180-pin Control Card Docking Station
   7. 1.6 Security
6. 2Hardware
   1. 2.1  Functional Block Diagram
   2. 2.2  Component Identification
   3. 2.3  Power Requirements
      1. 2.3.1 Power Input Using USB Type-C Connector
      2. 2.3.2 Power Status LEDs
      3. 2.3.3 Power Tree
      4. 2.3.4 Power Sequence
      5. 2.3.5 PMIC
   4. 2.4  Reset
   5. 2.5  Clock
   6. 2.6  Boot Mode Selection
   7. 2.7  JTAG Path Selection
   8. 2.8  Header Information
   9. 2.9  GPIO Mapping
   10. 2.10 Push Buttons
   11. 2.11 Test Points
   12. 2.12 Interfaces
       1. 2.12.1  Memory Interface
          1. 2.12.1.1 QSPI
          2. 2.12.1.2 Board ID EEPROM
       2. 2.12.2  Ethernet Interface
          1. 2.12.2.1 RGMII
          2. 2.12.2.2 PRU-ICSS
          3. 2.12.2.3 LED Indication in RJ45 Connector
       3. 2.12.3  I2C
       4. 2.12.4  Industrial Application LEDs
       5. 2.12.5  SPI
       6. 2.12.6  UART
       7. 2.12.7  MCAN
       8. 2.12.8  FSI
       9. 2.12.9  JTAG
       10. 2.12.10 Test Automation Header
       11. 2.12.11 LIN
       12. 2.12.12 MMC
       13. 2.12.13 ADC and DAC
   13. 2.13 HSEC Pinout and Pinmux Mapping
7. 3Software
   1. 3.1 SDK Installation
8. 4Hardware Design Files
9. 5Additional Information
   1. 5.1 Trademarks
   2. 5.2 E1 Design Hardware Modifications
10. 6References
    1. 6.1 Reference Documents
    2. 6.2 Other TI Components Used in This Design